Hifiverse

Bookshelf Speakers - Proficient Audio Protege LDA5

Description, images, technical data and specifications

Proficient Audio Protege LDA5
Image source - (c) Proficient Audio

The Protege LDA5 is a compact passive speaker from the Protege range of Proficient Audio, created as a Dolby Atmos enabled height module. Instead of being fixed in the ceiling, it sits on top of a front or rear speaker and uses an angled baffle to project sound upward so that it reflects off the ceiling toward the listening position. It comes in pairs finished in matte black and is intended for multichannel systems that decode Dolby Atmos or DTS:X formats.

Key specs that matter

Proficient fits a 5-1/4 inch graphite woofer and a 1 inch tweeter with a silk dome. Rated frequency response is 120 Hz to 20 kHz, nominal impedance is 6 ohm and sensitivity is 84 dB with 2.83 V at 1 m. Power handling is given as 60 W RMS. The cabinet is about 14.9 cm high, 17.5 cm wide and 26 cm deep, and the shipping weight for the pair is about 7.1 kg.

Engineering and use context

Proficient builds the LDA5 from MDF with rounded corners and a polymer coated finish, and fits removable black grilles held by neodymium magnets. The owner's manual advises placing the modules on top of the front left and right speakers, optionally also on the rear pair, slightly above ear level. The ceiling should be between about 2.3 and 3.7 m high and no higher than about 4.3 m, since the effect depends on a reflection from a flat surface above. The manual names the Protege LB62 bookshelf and the LFS6 floorstanding speaker as matching base speakers. Connection uses bare stripped wire, with about 13 to 19 mm of insulation removed before the strands are twisted and inserted into the terminals. Integrated flush single-slot wall mounts are also provided. Nothing should be placed on top of the cabinet, as that would sit over the upward firing drivers. Proficient gives a limited ten-year warranty to the original retail purchaser, which excludes damage from accident, misuse or inadequate shipping. For cleaning, the manual recommends a feather duster rather than wiping.

Pairing

The LDA5 requires a surround receiver or processor offering height channel outputs and Atmos or DTS:X decoding, set so that the height channels are assigned to reflecting modules. The limited bass extension means the receiver should be configured to route bass from these channels to the main speakers or a subwoofer, which in practice most multichannel setups already use.

Alternatives

Proficient offers no other Dolby Atmos height module in the Protege range.

Specifications

  • Model name

    Protege LDA5

  • Frequency Response low +/- 3dB (Hz)

    120

  • Frequency Response high +/- 3dB (Hz)

    20 000

  • Sensitivity (dB at 1 W/1m)

    84

  • Impedance (Ohms)

    6

  • Power amplifier requirements (W)

    60

  • Has internal amplification

    N/A

  • Internal amplification power (W)

    N/A

  • Size (sm)

    14,9 x 17,5 x 26

  • Weight (kg)

    N/A

  • Official link