The P-750u is a headphone amplifier from Luxman of Japan and a refined evolution of the P-700u. Its design combines the LECUA computerized attenuator, the ODNF Version 4.0 feedback circuit and a fully balanced output system. The main addition over the P-700u is a 4-pin XLR balanced headphone output. Luxman now lists the P-750u as discontinued, and the P-750u MARK II later replaced it.
Key specs that matter
Rated output unbalanced is 4 W + 4 W (8 ohms), 2 W + 2 W (16 ohms), 1 W + 1 W (32 ohms) and 53 mW + 53 mW (600 ohms). Balanced, it is 8 W + 8 W (16 ohms), 4 W + 4 W (32 ohms) and 213 mW + 213 mW (600 ohms). Frequency response is 20 Hz - 20 kHz (+0, -0.1 dB) and 10 Hz - 170 kHz (+0, -3.0 dB). THD is 0.003% unbalanced and 0.002% balanced (1 kHz), and S/N ratio (IHF-A) is 113 dB and 116 dB. Input sensitivity and impedance are 1.0 V/15 kilohms unbalanced and 2.0 V/40 kilohms balanced. The unit measures 440 x 92 x 400 mm (W x H x D) and weighs 13.3 kg.
Engineering and use context
ODNF (Only Distortion Negative Feedback) is Luxman's own circuit, in which only the distorted elements of the signal from the output amplification circuit are fed back. Version 4.0 adds a triple-paralleled input stage error detection circuit, and a paralleled first stage with a Darlington-equipped second stage lowers output impedance and raises the signal-to-noise ratio. Each of the four identical output channels carries its own ODNF 4.0 circuit. Balanced headphones are driven in a Bridge Tied Load (BTL) configuration, which according to Luxman improves left-right separation and power supply regulation and reduces cross-modulation distortion. For unbalanced headphones two channels per side run in parallel, doubling the output current capacity.
LECUA is a solid-state (IC) attenuator that minimises level deviation between left and right channels at low volume. A three-step sensitivity selector for headphones of different impedance and efficiency and the balance control are both governed by LECUA. Headphone outputs are a standard stereo jack, a stereo pair of 3-pin XLR sockets and a 4-pin XLR socket.
Inside is an OI-core power transformer with two 10,000 µF custom block capacitors in the power amplifier stage and two 3,300 µF in the pre-driver stage. A dual base chassis of 3 mm sheet steel lowers the centre of gravity, and gradation cast iron legs come from Luxman's 900 series separates.
Pairing
A line-level source with balanced or unbalanced outputs is required. Headphones with a 4-pin XLR plug, dual 3-pin XLR plugs or a standard stereo jack connect directly.
Alternatives
The P-100 CENTENNIAL is Luxman's later headphone amplifier, with the LIFES feedback engine and 4-pin XLR and 4.4 mm balanced outputs.