The P-100 CENTENNIAL is a solid-state headphone amplifier and the first model Luxman of Japan released for its 100th anniversary. It is also the first Luxman headphone amplifier to use the LIFES amplification feedback engine, and its circuitry is fully balanced from input to output.
Key specs that matter
Rated output from the unbalanced output is 4 W per channel into 8 ohms, 2 W into 16 ohms, 1 W into 32 ohms and 53 mW into 600 ohms. Balanced drive gives 8 W into 16 ohms, 4 W into 32 ohms and 213 mW into 600 ohms. Instantaneous maximum output into 8 ohms is 5 W unbalanced and 20 W balanced. Input sensitivity and impedance are 1.0 V / 14 kohms unbalanced and 2.0 V / 28 kohms balanced. Frequency response is 20 Hz - 20 kHz (+0, -0.1 dB) and 10 Hz - 175 kHz (+0, -3 dB). THD at 1 kHz is 0.0025% unbalanced and 0.0015% balanced, and S/N (IHF-A) is 117 dB and 119 dB. Power consumption is 67 W, or 47 W with no signal. Its case measures 446 x 136 x 401 mm and weighs 19.7 kg.
Engineering and use context
LIFES is an evolution of ODNF, and Luxman states that it reduces distortion at the output by more than half and improves the signal-to-noise ratio by over 3 dB. Inside are four independent amplifier blocks. For the balanced outputs they work in a BTL (bridge-tied load) configuration, while the unbalanced output uses parallel drive with two amplifier circuits per channel.
Headphone terminals are a 6.3 mm unbalanced jack plus a 4-pin XLR and a 4.4 mm jack, both balanced. A separate 3-pin XLR output serves the Parallel Balanced BTL mode, in which two P-100 CENTENNIAL units are linked and all eight amplifier blocks drive one pair of headphones, doubling the current output per channel.
Volume is set by LECUA-EX, a solid-state IC design with 200 steps of 0.5 dB. A volume limit has six levels (OFF, -10, -20, -30, -40 and -50 dB), and input sensitivity switches between 0, -6 and -12 dB. Two custom OI-type power transformers serve the left and right channels independently, and an EI-type transformer supplies peripheral circuitry such as relays and LED indicators. Luxman uses a rigid, loopless chassis to prevent earth loops, and four density-gradient cast-iron feet are included.
Pairing
Sources with unbalanced or balanced line outputs connect directly. Headphones with 4-pin XLR or 4.4 mm balanced plugs use the BTL outputs. Parallel Balanced BTL mode requires a second P-100 CENTENNIAL and a compatible headphone cable.
Alternatives
The Luxman P-750u is an earlier headphone amplifier of the brand with LECUA volume control and a BTL balanced output stage.