The TOMEI Kensei is a 211 single-ended triode stereo power amplifier from Audio Note (UK). It shares the circuit design of the ONGAKU Kensei and JINRO Shochu power amplifiers and sits between them. Its transformers combine copper primary windings with silver secondary windings. Audio Note rates it at Level 4, and it fulfils all criteria of that level - pure Class A operation, zero negative feedback, a single-ended output stage, tube rectification, directly heated triode operation and Level 4 materials and component quality.
Key specs that matter
Maximum output is about 20 W per channel into 4 or 8 ohm loads. Input impedance is 2.4 kOhm (line level), input sensitivity is 450 mV for full output and channel balance is ±0.3 dB. Its tube complement is two 211 output triodes, two 6V6 signal tubes and two 5R4WGB rectifiers. Mains input is AC 100-120 V / 220-240 V, 50/60 Hz, with a maximum consumption of 200 W. Dimensions are 305 x 305 x 640 mm (H x W x D), and weight is 38 kg.
Engineering and use context
Level 4 components are used throughout, including Audio Note tantalum resistors and Audio Note foil capacitors. Output transformers are designed and made in-house.
Balanced XLR input sockets sit towards the front of the left side panel, together with a ground post. Each channel has two colour-coded binding posts, and mains connection is through an IEC 320 inlet with the fuse and a spare in its fuse drawer. Audio Note gives three cable configurations - XLR with the screen connected at both ends, XLR with the screen connected at the preamplifier end only to eliminate ground loops, and an RCA single-ended preamplifier output to the XLR balanced input.
Each 211 triode has a small locating pin on its base and is twisted clockwise into its socket until it locks. Bedding in takes about 200 hours, and a warm-up of 30 to 45 minutes is required at each switch-on. Tube life is about 6000 hours, with replacement in matched pairs only. At least 50 cm of free space above the chassis is required for ventilation. The top plate comes in anodised aluminium or black anodised aluminium.
Pairing
A preamplifier with a balanced XLR output is required, or an RCA output with an RCA-to-XLR cable. The output terminals allow 4 ohm or 8 ohm loudspeakers. High-sensitivity loudspeakers are required.
Alternatives
The ONGAKU Kensei uses the same circuit with silver/silver output and interstage transformers on AN-Perma 50 nickel C-cores and GE VT4-C output triodes.