The FLS4 is a stereo power amplifier from Audia Flight, the Italian company founded in Civitavecchia in 1996 by Massimiliano Marzi and Andrea Nardini. It belongs to the FLS series and takes numerous design elements from the Strumento series. Audia Flight offers it in a silver or black finish.
Key specs that matter
Output power per channel is 200 W RMS into 8 ohms, 380 W into 4 ohms and 700 W into 2 ohms, the last figure measured without current limitation. Gain is 29 dB and input sensitivity is 1.41 V RMS. Input impedance is 7.5 kohms on both the unbalanced and the balanced inputs. Frequency response is 0.3 Hz - 0.7 MHz (1 W RMS, -3 dB, measured before the output inductor). Slew rate is above 160 V/µs into 8 ohms, THD is below 0.05% and S/N ratio is 110 dB. Damping factor exceeds 650 into 8 ohms. Power consumption is 170 W with no signal, 840 W with both channels at 200 W RMS into 8 ohms and less than 1 W in stand-by. Dimensions are 450 x 180 x 440 mm (W x H x D), and weight is 35 kg.
Engineering and use context
Inside, the circuitry is fully balanced and the output stage uses 32 power transistors. Audia Flight's own class A current-feedback gain stage is fully enclosed in an aluminium housing and encapsulated in epoxy resin for thermal stability and isolation from interference.
A 2,000 VA toroidal transformer supplies the output stage. It is dual-shielded with ferromagnetic layers and fully resin-encapsulated. Sixteen 18,000 µF / 50 V low-impedance capacitors, 288,000 µF in the main supply, form two high-current power supplies per channel. Each channel also has four independent regulated stages, two for the input circuits and two for the current-feedback gain stage. A separate 15 VA toroidal transformer powers the logic control and protection circuits, isolated from the audio signal path. In total the FLS4 has twelve independent power supplies. Its PCBs are custom-designed with extra-thick high-purity copper traces. Instead of conventional fuses, a current sensor monitored by a microprocessor protects the amplifier.
Each chassis part starts as an aluminium casting, is CNC-machined, inspected and hand-polished. Critical areas are shot-peened and anodised, and the legends are silk-screened.
Pairing
A preamplifier with balanced or unbalanced outputs is required. The matching preamplifier in the FLS series is the FLS1.
Alternatives
The Strumento N°4 is Audia Flight's stereo power amplifier in the higher Strumento series.