The BD-225 is a power amplifier from Bryston of Dwight, Ontario, and belongs to the BD series, which the Canadian company announced as its first Class D amplifiers. Its common chassis takes one to six independent Class D modules, so the same model is built as a stereo, mono or multichannel amplifier. A two-channel version cost USD 3,495, and a one-channel version CAD 4,135.
Key specs that matter
Continuous output is 225 W RMS per channel into 8 ohms and 450 W into 4 ohms. With all channels driven, the chassis provides 1,250 W continuous and 3,750 W dynamic (100 ms). Frequency response is 1 Hz - 45 kHz (6 ohms, -3 dB). Input sensitivity is 1.5 V, voltage gain is 29 dB and signal-to-noise ratio is 103 dB at full power. Storage capacitance totals 108,000 µF. Inputs are balanced XLR and single-ended RCA, with a 12 V trigger. Mains voltage is 115 or 230 V. The chassis measures 133 x 450 x 425 mm (H x W x D) and weighs 24 kg.
Engineering and use context
Bryston pairs its proprietary Class D amplifier modules with a linear power supply built on a toroidal transformer and large storage capacitance. Bryston names the switching supply typical of Class D designs as one of their concerns. In each module, pulse width modulation drives a MOSFET switching transistor, and a low-pass filter at the output restores the analogue signal. Cooling is fully passive, through heat sinks with no fans.
Each channel is independent, and the owner's manual describes the amplifier as a discrete multi-channel design in a single chassis. Bryston lists multichannel active or passive systems and custom-install zones as uses for the modular layout. Power enters through an IEC-320 C14 inlet. A rear mains switch and a front push button set operation or standby, and a blue LED shows the on state. For the 12 V trigger, a 3.5 mm connector is used. Output binding posts accept banana plugs, spade lugs up to 16 mm wide on the 8 mm post, or bare wire up to 3 gauge. Faceplates can be ordered in personalised colours, with custom colours on request. The owner's manual lists a five-year Bryston warranty.
Pairing
A preamplifier or AV processor with balanced or single-ended outputs is required, and each channel takes either an XLR or an RCA cable, not both. A preamplifier with a 12 V trigger output allows remote switch-on.
Alternatives
The Bryston BD-325 uses the same chassis with 325 W per channel into 8 ohms, 650 W into 4 ohms and 144,000 µF of storage capacitance.