The BasX A3+ is a three-channel power amplifier in Emotiva's BasX range, introduced on 1 February 2025 at a list price of USD 799. It updates the BasX A3 of 2021 with balanced XLR inputs and microprocessor-controlled monitoring. Emotiva specifies it for a 3.1 channel system or for the left, centre and right speakers of a surround system run from a receiver.
Key specs that matter
All channels driven, the A3+ is rated at 140 W RMS per channel into 8 ohms (20 Hz - 20 kHz, THD < 0.1%) and 200 W RMS per channel into 4 ohms (1 kHz, THD < 1%). Two channels driven, output is 150 W per channel into 8 ohms and 250 W per channel into 4 ohms. Power bandwidth is 20 Hz - 20 kHz (±0.02 dB) at rated power, and broad band frequency response is 10 Hz - 80 kHz (+0/-1.8 dB). THD+N is < 0.02% (A-weighted). Signal-to-noise ratio is > 112 dB referenced to rated power (A-weighted), and damping factor is > 500 into 8 ohms. Input sensitivity is 1.25 V for rated power into 8 ohms, gain is 29 dB and input impedance is 27 kohms. Minimum recommended load is 4 ohms per channel. Dimensions are 432 x 102 x 394 mm (W x H x D, without connectors), and weight is 11.3 kg.
Engineering and use context
Inside is a heavy-duty linear power supply with an oversized toroidal transformer and a high current, short signal path Class A/B output stage. Microprocessor-controlled monitoring and protection guard against excessive operating temperature, shorted speaker connections and ground faults. Circuit boards are double-sided FR4 with plated-through holes. Its heavy steel chassis has a milled aluminium faceplate, and Emotiva gives a three-year warranty.
Every channel has both a balanced XLR and an unbalanced RCA input. Speaker outputs are 5-way binding posts. There is a 5 - 12 V (AC or DC) trigger input and a 12 VDC trigger output for loads up to 120 mA. Mains of 115 or 230 VAC at 50/60 Hz is detected automatically. The front panel has a standby push button, an amber standby LED and one blue status LED per channel, and the rear panel carries the AC rocker switch and a switch that disables the status LEDs.
Pairing
An AV processor, stereo preamplifier or AV receiver with pre-outs is required, connected over XLR or RCA. Speakers of 4 ohms or higher per channel are within the rated load.
Alternatives
The original BasX A3 is the earlier three-channel version with RCA inputs only.