The AMP VI is a dual-mono stereo power amplifier from Accustic Arts of Lauffen, handmade in Germany, with a completely isolated power supply for each channel. Accustic Arts states that it increased the output power once again in response to numerous customer requests for more power. Its case has the same dimensions as the MONO VI monoblock. Finishes are aluminium with chrome, black with gold and black with chrome, and US prices have been USD 66,990 in chrome and USD 68,990 in gold.
Key specs that matter
Rated power output at THD+N 0.1% is more than 2 x 1,600 W into 2 ohms, more than 2 x 1,500 W into 4 ohms and more than 2 x 950 W into 8 ohms. Minimum loudspeaker impedance is 2 ohms. Voltage gain is 30.0 dB. Frequency response is 10 Hz - 50 kHz (+0/-0.5 dB) at 10 W into 4 ohms. Damping factor is above 500 at 1 kHz and 10 W into 4 ohms, where THD+N is 0.003%. Signal-to-noise ratio is -96 dBA (ref. 6.325 V), and crosstalk is 105 dB at 1 kHz. Input impedance is 2 x 16 kohms balanced (XLR) and 15 kohms unbalanced (RCA). Power consumption without load is approx. 240 W. Dimensions are 328 x 530 x 545 mm (H x W x D), weight is approx. 82 kg, and the flight case adds 22 kg.
Engineering and use context
Its output stage uses 40 selected MOS-FET output transistors, twice the count of the AMP IV. Two magnetically shielded and encapsulated toroidal core transformers supply the channels, each protected by its own fuse (FUSE 1 and FUSE 2). Power supply capacity is more than 220,000 µF, in capacitors made in Germany. Contact surfaces of the components are gold-plated to improve contact resistance, and generously dimensioned heat sinks keep the operating temperature constant and low.
Accustic Arts includes its switchable damping factor linearization. A protective circuit acts against clipping, HF oscillations and too high DC offset, and switch-on current limitation is integrated. Two XLR and two RCA inputs are provided, and the input type is switchable. Each channel has WBT terminal pairs A and B and a ground contact for shielded speaker cables, and a MUTE switch on the rear turns off the speaker outputs.
The housing is massive, resonance-optimised aluminium. It carries an inlay of massive brass, high-gloss polished and chromed.
Pairing
A preamplifier with a balanced XLR or unbalanced RCA output is required. The gold-plated speaker terminals allow bi-wiring or bi-amping.
Alternatives
The AMP IV is the smaller stereo power amplifier in the Accustic Arts REFERENCE-SERIES, rated at 2 x 400 W into 8 ohms.