The MONO IV is a reference class mono power amplifier from Accustic Arts Audio GmbH of Lauffen, handmade in Germany. Its case has the same dimensions as the stereo AMP IV. In the United States it has been offered at USD 69,990 with chrome trim and USD 72,990 with gold trim.
Key specs that matter
Voltage gain is 30.0 dB. Rated power output is approx. 900 W into 2 ohms, approx. 760 W into 4 ohms and max. 510 W into 8 ohms, with 2 ohms as the minimum loudspeaker impedance. Input impedance is 2 x 20 kohms on the balanced XLR input and 100 kohms on the unbalanced RCA input. Signal-to-noise ratio is -96 dBA (ref. 6.325 V). THD+N is 0.004% into 4 ohms at 1 kHz and 10 W, and intermodulation distortion is 0.007% at 10 W into 4 ohms. Power consumption without load is approx. 120 W. Dimensions are 340 x 470 x 440 mm (H x W x D), and weight is approx. 42 kg, plus 12 kg for the flight case.
Engineering and use context
Its single-channel output stage uses 20 selected MOS-FET output transistors. Power comes from two magnetically shielded and encapsulated toroidal core transformers with a maximum total transformer power of 1200 VA. Smoothing capacity exceeds 80,000 µF, in capacitors made in Germany. A protective circuit acts against clipping, HF oscillations and too high DC offset, and generously dimensioned heat sinks keep the operating temperature constant and low. On the front, two red LEDs indicate protection mode during warm-up or an output stage error and go out after about 5 seconds, while a blue LED shows that the amplifier is ready for operation.
At the rear, an INPUT SELECTION button chooses between XLR and RCA, and only one input is active at a time. Accustic Arts also has a DAMPING FACTOR CONTROL switch here. Set to ON, it lowers the damping factor slightly and linearises it over a wide frequency range. Set to OFF, the damping factor is at its maximum but decreases considerably from 5 kHz. A MUTE switch turns off the speaker outputs for short interruptions, and a ground contact is provided for shielded speaker cables. Its housing is massive, resonance-optimised aluminium with an inlay of massive brass, high-gloss polished and chromed, and the mains power switch sits on the front panel.
Pairing
A preamplifier with a balanced XLR or unbalanced RCA output is required. Two MONO IV units are needed for a stereo pair. The gold-plated WBT terminal pairs A and B are identical and allow bi-wiring.
Alternatives
The MONO VI is the larger mono power amplifier in the Accustic Arts REFERENCE-SERIES, rated at more than 950 W into 8 ohms.