The MAX is Audionet's reference mono power amplifier, a microprocessor-controlled design from the Berlin company. Its predecessor was the AMP II MAX. It uses the ULA (Ultra-Linear-Amplifier) circuit topology, which Audionet originally invented for medical engineering. Each monoblock weighs 38 kg.
Key specs that matter
Output is 400 W into 8 ohms, 700 W into 4 ohms and 1,100 W into 2 ohms. Frequency response is 0 Hz - 500 kHz (-3 dB). Damping factor is above 1,800 at 10 kHz and above 10,000 at 100 Hz. Audionet quotes THD+N of -106 dB (1 kHz, 25 - 700 W into 4 ohms), intermodulation below -110 dB (SMPTE 100 Hz / 20 kHz, 4 to 1, 50 W into 4 ohms) and SNR above 125 dB. Input impedance is 37 kohms, 100 pF for the RCA input and 3 kohms, 100 pF for the XLR input. Maximum power consumption is 2,000 W at 120 or 230 V. Each unit measures 215 x 285 x 500 mm (W x H x D).
Engineering and use context
Audionet chose a mono design for absolute channel separation, and the assembly is magnetically and capacitively optimised. Signal paths are minimal and completely DC coupled, with no coils, chokes or power relays. Gold-plated precision relays switch electronically between the RCA and XLR inputs.
At the input sits a cascaded and bootstrapped differential amplifier with a low-noise monolithic dual FET. A double cascade decouples the source signal from the driver and output stages, and a cross-linked correction circuit in the driver stage linearises output stage distortion locally in real time. Eight hand-selected power MOSFETs with an actively controlled bias current of 0.6 A form the output stage.
Four separate power supplies serve the controller, the input and driver stages, and the positive and negative operating voltages of the power stage. An 80 VA toroidal transformer powers the input and driver stages, while two 1,000 VA toroidal transformers supply the positive and negative halves. Four high-current capacitors provide 156,000 µF of filtering, and discrete MOSFET regulators stabilise the supply voltage. Components are measured and matched in pairs during manufacture.
A microprocessor monitors DC, HF, temperature and overload, disconnects the MAX from the mains on a fault and names the cause on its two-line display. Mains phase detection is automatic. Instead of a 12 V trigger, switch-on is by the optical Audionet Link or by the input signal.
Pairing
A preamplifier with a low output impedance is required for the XLR input. The two pairs of Furutech terminals allow bi-wiring. With preamplifiers without Audionet Link, the MAX switches on by input signal sensing.
Alternatives
Audionet's AMP is a smaller mono power amplifier from the same range.