The AMP I V2 is a stereo power amplifier from Audionet of Berlin. It uses Audionet's ULA (Ultra-Linear-Amplifier) technology, a circuit topology originally invented for medical engineering, and it is assembled as a dual-mono amplifier.
Key specs that matter
Output is 2 x 200 W into 8 ohms, 2 x 300 W into 4 ohms and 2 x 450 W into 2 ohms. Bridged, it gives 1 x 600 W into 8 ohms and 1 x 900 W into 4 ohms. Frequency response is 0 Hz - 300 kHz (-3 dB), and damping factor is above 10,000 at 100 Hz. THD+N is below -102 dB (1 kHz, 35 W into 2 ohms, 20 Hz - 20 kHz), intermodulation is below -110 dB (SMPTE 100 Hz / 20 kHz, 4 to 1, 50 W into 4 ohms), channel separation exceeds 100 dB at 1 kHz and SNR exceeds 106 dB at 10 Veff. Input impedance is 37 kohms, 220 pF. Two Furutech RCA line inputs and two pairs of rhodium-plated Furutech 4 mm speaker jacks are on the rear panel. Mains connection is 120 or 230 V, 50 - 60 Hz, with a maximum consumption of 1,500 W. Dimensions are 430 x 175 x 315 mm (W x H x D), and weight is 28 kg.
Engineering and use context
Audionet describes the layout as magnetically and capacitively optimised. This dual-mono construction minimises interaction between the two channels and between the input, correction and output stages. Circuit size was reduced for better high-frequency behaviour, and the signal path is completely DC coupled, with no capacitors, coils, chokes or relays in it.
Each channel has a double-differential input stage with monolithic dual FETs and a gain-bandwidth product above 1 GHz. An 80 VA toroidal transformer with separate windings per channel powers these input stages, and double bootstrapping decouples them from the power stages. Four power MOSFETs with an actively controlled bias current of 0.4 A make up each output stage. Distortion is compensated locally by a real-time correction stage. Two 700 VA toroidal transformers and four impulse-stable high-current capacitors totalling 188,000 µF supply the power stages, with discrete MOSFET regulators.
Filter capacitors are made to Audionet's specification in the USA, and the electrolytic capacitors with silk dielectric come from Japan. Mica capacitors, selected high-voltage foil capacitors and silver-gold alloy internal wiring complete the parts list. A control unit with its own power supply monitors DC, HF, temperature and overload and disconnects the amplifier from the mains when necessary.
Pairing
An Audionet preamplifier with Audionet Link can switch the AMP I V2 on remotely over the optical link. The 2 ohm rating allows low-impedance loudspeakers.
Alternatives
The AMP I V2 is the only stereo model among Audionet's current power amplifiers, so the closest model is the AMP mono power amplifier.