The CANTA Integrated is a hybrid stereo amplifier made by Vinnie Rossi in Worcester, Massachusetts, and the second product of the CANTA series, which opened in August 2026 with the CANTA Phono Preamplifier. It was announced on 1 October 2026 without a price, alongside a planned CANTA Preamplifier and CANTA Stereo Power Amplifier. The design is fully analogue, with no digital input section, and it is built in the USA with a 10-year warranty.
Key specs that matter
Output is 125 W RMS per channel into 8 ohm and 250 W RMS per channel into 4 ohm. Of the four line inputs, two are balanced XLR and two are RCA, each presenting 20 kohm to the source. Frequency response runs from 5 Hz to 100 kHz within 0.5 dB, signal-to-noise ratio exceeds 100 dB and THD+N stays below 0.1% across 20 Hz to 20 kHz. Output impedance is under 0.05 ohm at the speaker terminals and under 100 ohm at the line outputs. The case measures 413 x 324 x 70 mm including knobs, jacks and feet, and weighs 10 kg. The mains input accepts 100 to 264 V at 50 or 60 Hz.
Engineering and use context
A dual-mono Class A line stage uses a single 6SN7 triode per channel for the voltage gain near the start of the signal path. Current comes from a dual-mono Class AB output stage with a matched pair of lateral MOSFETs on each rail. Power is drawn from a switch-mode supply of Vinnie Rossi's own design, combined with power factor correction and Belleson super-regulation, and rated at over 1,000 W peak. Signal and power paths are kept very short. Volume is set by a 100-step resistor ladder rather than a potentiometer. Each input stores its own gain setting - low at 22 dB, medium at 28 dB or high at 34 dB - and its own balance position out of 12 steps. A high-resolution LCD and two Swiss rotary encoders with 24 and 48 positions sit on the front, and a USB-C port takes firmware updates. The housing starts as a single billet of aluminium that is CNC-machined, bead-blasted and anodised, and it handles heat dissipation and shielding. An aluminium IR remote is supplied, and the amplifier ships in an airtight hard case.
Pairing
A Home Theater Bypass mode hands volume control of one input to a surround processor or AV receiver, so the same front speakers and power stage serve both a stereo system and a cinema setup. The near-zero output impedance and the large current reserve into 4 ohm make it a fit for demanding low-impedance floorstanding speakers. Volume-controlled line outputs on XLR and RCA can send signal to a powered sub or a further stereo power stage, while turntable owners can add the CANTA Phono Preamplifier for vinyl.
Alternatives
The Vinnie Rossi L2i is an earlier integrated from the same maker that also uses 6SN7 triodes in a dual-mono input stage, rated at 100 W into 8 ohm.