Hifiverse

Tonabnehmer - Clearaudio DA VINCI V2

Beschreibung, Bilder, technische Daten und Spezifikationen

Clearaudio DA VINCI V2
Bildquelle - (c) Clearaudio

The da Vinci V2 is a moving coil cartridge from Clearaudio, and its current version is the da Vinci V2.1. Clearaudio describes it as the product of intensive research at its home in Erlangen, Germany. It is finished in a red livery on a coated aluminium body, unlike the wooden bodies of the Concerto V2.1 and Stradivari V2.1.

Key specs that matter

Output voltage is 0.5 mV (5 cm/s) and cartridge impedance is 50 ohms. Frequency response is 20 Hz - 20 kHz, channel separation 25 - 30 dB and channel balance under 0.5 dB. The cantilever is boron with a Clearaudio Prime Line diamond cut. Tracking ability is 80 µm, stylus compliance 15 µ/mN, and the recommended tracking force is 2.8 g (±0.2 g). Coils are 24 carat gold in an absolute pivot point symmetrical arrangement. Total system weight is 6.8 g. A two-year warranty is subject to return of the completed warranty card within 14 days of purchase.

Engineering and use context

Its aluminium body carries an extra-hard anodised coating 30 microns thick, which Clearaudio lists as a ceramic coating. According to the company, this construction gives efficient resonance dissipation together with a rigid, low-resonance body. Inside is a patented construction with eight magnets, laid out for the highest possible field line density.

Each gold coil sits in strict symmetry around the pivot point, and Clearaudio links this arrangement to precise signal acquisition. Low total weight, a lightweight and rigid boron cantilever and a finely ground diamond are the three points the maker lists as the basis of the cartridge.

Pairing

A phono stage with an MC input or a step-up transformer is required. An MC stage with load settings for low-impedance coils matches it. The tonearm must reach the recommended tracking force with this cartridge mass.

Alternatives

The Clearaudio Concerto V2.1 is a moving coil cartridge with the same output, 24 carat gold coils and boron cantilever in a satiné wood body with a metal inlay.

Spezifikationen

  • Modellbezeichnung

    DA VINCI V2

  • Typ

    MC

  • Nadel

    Clearaudio Prime Line

  • Gehäuse

    Aluminium with 30 micron ceramic coating

  • Nadelträger

    Boron

  • Spulen

    24 carat gold

  • Ausgangsspannung (mV@5cm/sec)

    0.5

  • Untere Grenzfrequenz +/- 3dB (Hz)

    20

  • Obere Grenzfrequenz +/- 3dB (Hz)

    20 000

  • Innenwiderstand (Ohm)

    50

  • Kanaltrennung (dB / 1,000 Hz)

    25 – 30

  • Nadelnachgiebigkeit (×10-6cm/dyne at 100Hz)

    15μ/mN

  • Empfohlene Abschlussimpedanz (Ohm)

    N/A

  • Empfohlene Tonarme

    N/A

  • Gewicht (g)

    6.8

  • Offizieller Link