The SCS70 Pro is a free-standing active subwoofer from the professional range of ATC, which hand-builds its products at Aston Down in Gloucestershire, England. ATC names the SCM12, SCM20, SCM25A Pro, SCM45A Pro and SCM50A Pro studio monitors as its partners, for stereo and surround use, including formats with height channels. An in-wall variant with a remote amplifier, the SCS70iW Pro, is also available.
Key specs that matter
It is a sealed box design with one 314 mm ATC SS75-314SC sub driver, rated at 8 ohms. Low-frequency cut-off is 22 Hz (-6 dB, half space, low-pass filter at 80 Hz). Maximum SPL is 110 dB continuous and 116 dB peak (IEC weighted pink noise, 1 m, half space, low-pass filter at 80 Hz). Output power is 300 W into 8 ohms, with THD+N below 0.003% at 100 Hz and full power. Sensitivity is +4 dBu for 88 dBC (single channel driven, gain +6 dB, level 0 dB), and 6 dBu (1.55 V rms) gives full power. Dimensions are 568 x 464 x 500 mm (H x W x D) and net weight is 44 kg.
Engineering and use context
The amplifier is a grounded source MOSFET design operating in class A-B, and it is convection cooled. Four low-pass settings of 50, 65, 80 and 320 Hz are available, each a fourth-order Linkwitz-Riley filter. Gain is switchable to 0, +6 or +10 dB, and the level control runs from 0 to -11 dB in 1 dB steps, for a total range of 21 dB. Phase is adjustable from 0 to 180 degrees, and polarity can be set in-phase or out-of-phase relative to the input. An ATC Active FET momentary gain reduction limiter is built in, with a front-panel LED showing when it is active.
On the rear panel are two female XLR inputs (20 kohms differential, CMRR 90 dB at 200 Hz) and two male XLR outputs that pass the signal on unfiltered and unprocessed. Remote muting uses a latching footswitch, supplied separately, on a 6.35 mm jack. Mains voltage is factory set to 220-230 V or 115 V. Power consumption is 8 W (14 VA) at idle, 170 W (230 VA) at one-eighth power and 500 W (600 VA) at full power. ATC covers the subwoofer with a 6-year warranty.
Pairing
A source with balanced XLR outputs is required, such as an audio interface, monitor controller or preamplifier. The unfiltered XLR outputs connect to the main monitors.
Alternatives
The SCS120 Pro is the other free-standing active subwoofer in ATC's professional range.