The C4 Sub Mk2 is a 314 mm active subwoofer from ATC, hand-built in England. ATC names it as a partner for its SCM19, SCM20, SCM40, SCM50 and SCM100 loudspeakers, for stereo, home cinema and AV applications. Its proprietary drive unit and amplifier are integrated into a single system in a sealed box.
Key specs that matter
The drive unit is one SS75-314SC, 314 mm, 8 ohms. Low frequency cut-off is 22 Hz (-6 dB, half space, low pass filter at 80 Hz). Amplifier output is 300 W into 8 ohms, with THD+N below 0.003% at 100 Hz and full output over a 90 kHz bandwidth. Maximum SPL is 110 dB continuous and 116 dB peak (IEC weighted pink noise, 1 m, half space), and sensitivity is +4 dBu ref. 88 dBC. Electronic frequency response runs from below 2 Hz (-3 dB) to 320 Hz (-6 dB). Input sensitivity is 1.55 Vrms for full power. Each unit measures 568 x 464 x 500 mm (H x W x D) and weighs 42 kg.
Engineering and use context
ATC engineered the SS75-314SC in-house to reproduce frequencies below 160 Hz. According to ATC, its short coil operates within a very long magnetic gap for minimal distortion across the full dynamic range. Amplification is a grounded source MOSFET based Class A-B stage, convection cooled. Low pass filters at 50, 65, 80 and 320 Hz are 4th order Linkwitz Riley. Gain switches between 0, +6 and +10 dB, and level runs from 0 to -11 dB in 1 dB steps, a total range of 21 dB with the gain switch. Phase is variable from 0 to 180°, and a polarity control selects in-phase or out-of-phase. Limiting is by ATC active FET momentary gain reduction.
On the rear panel are two female XLR inputs (pin 2 hot, CMRR 90 dB at 200 Hz, 20 kohms differential) and two male XLR outputs with 100 ohm output impedance, carrying the unfiltered signal. A 6.35 mm jack socket allows muting with a latching footswitch, supplied separately. Power consumption is 8 W at idle and 500 W at full power, and the mains voltage is factory set. Finishes include natural and gloss veneers, satin black and white, piano black and piano white, with others to special order, and the warranty runs 6 years.
Pairing
A preamplifier or processor with balanced outputs is required. Its XLR outputs pass the unfiltered signal to the main loudspeakers or their power amplifiers. The 320 Hz filter position allows an AV processor to set the crossover instead.
Alternatives
The ATC C6 Sub is the larger model, with a 375 mm SL bass driver and a 450 W Class G amplifier.