Hifiverse

Kopfhörerverstärker - Schiit Audio MIDGARD

Beschreibung, Bilder, technische Daten und Spezifikationen

Schiit Audio MIDGARD
Bildquelle - (c) Schiit Audio

The Midgard is a fully discrete headphone amplifier and preamplifier from Schiit Audio, listed at USD 219. Schiit calls it a Halo headphone amp and preamp. It replaced the Magnius, which used op-amps, and like the Asgard it is a discrete current-feedback design, but it runs from an external wall-wart transformer and takes no internal DAC module. The chassis is made in California, the PCBs in California or Nevada, and the unit comes together in Corpus Christi, Texas. Its warranty is a 2-year limited one, and in Norse mythology Midgard is the earth.

Key specs that matter

Maximum power is 5.5 W RMS per channel into 16 ohms, 4.8 W into 32 ohms, 3.2 W into 50 ohms, 750 mW into 300 ohms and 375 mW into 600 ohms. Frequency response is 20 Hz - 20 kHz (±0.01 dB). THD+N is below 0.0001% (-118 dB) in low gain and below 0.0003% (-108 dB) in high gain, both at 4 V RMS into 300 ohms. CCIF IMD is below -112 dB and -110 dB under the same conditions. SNR exceeds 128 dB in low gain and 118 dB in high gain (ref. 4 V RMS), and crosstalk is below -80 dB (20 Hz - 20 kHz, 300 ohms). Output impedance is below 0.1 ohm at the 6.35 mm TRS jack, approximately 2 ohms at the Neutrik 4-pin XLR and 75 ohms at the preamp outputs. Input impedance is 50 kohms. Gain is 1 (0 dB) or 5 (14 dB). Size is 229 x 152 x 38 mm and weight 0.9 kg, with consumption of 3 W idle and 16 W maximum.

Engineering and use context

Its topology is fully discrete, DC coupled and highly linear in open loop, with low loop feedback. Internally it is a single-ended amplifier, so the TRS and XLR jacks give the same power. Balanced inputs are converted to single-ended, and the balanced outputs are derived from the single-ended signal. The 4-pin XLR carries Halo, a mixed-mode feedback system that puts the headphone driver into the feedback loop and needs separate left and right ground returns, while the TRS is a standard output. Current-sensing protection sits out of the signal path, with overcurrent sensing and output lift, a muting relay and a failsafe DC power input. A 14 - 16 VAC wall-wart transformer supplies stacked regulated rails of ±20 V and ±30 V with 10,000 µF of total capacitance. Film and silicon capacitors, MELF resistors, Neutrik connectors, Alps switches and the 27 mm Alps RK27 volume potentiometer are used.

Pairing

XLR and RCA inputs accept balanced and single-ended sources. The matching DAC is the Mimir, of the same size. Preamp outputs on XLR and RCA stay live with headphones connected. Schiit states it is silent with IEMs.

Alternatives

The Schiit Asgard X is a class A modular headphone amplifier and preamplifier from the same range.

Spezifikationen

  • Modellbezeichnung

    MIDGARD

  • Maximale Leistung, 32 Ohm (mW RMS per channel)

    5500

  • Maximale Leistung, 50 Ohm (mW RMS per channel)

    3200

  • Maximale Leistung, 300 Ohm (mW RMS per channel)

    750

  • Maximale Leistung, 600 Ohm (mW RMS per channel)

    375

  • Untere Grenzfrequenz +/- 3dB (Hz)

    20

  • Obere Grenzfrequenz +/- 3dB (Hz)

    20 000

  • Verstärkung (dBu)

    1 or 5

  • Klirrfaktor (THD) (% at 1V RMS, 300 ohms)

    0.0003

  • Signal-Rausch-Abstand (dB)

    >128

  • Intermodulationsverzerrung (IMD) (%, CCIR, 300 Ohms)

    <112

  • Übersprechen (dB, 20Hz-20KHz, 300 Ohms)

    80

  • Ausgangsimpedanz (Ohms)

    0.1 + 75 (pre amp)

  • Abmessungen (mm)

    229 × 152 × 38

  • Gewicht (kg)

    0.9

  • Offizieller Link

Weitere Komponenten