The P-4600 is a Class AB stereo power amplifier from Accuphase and the fourth generation of the P-4000 series since the P-4100 of 2008. Accuphase places this series in the tradition of its P-300 of 1973, and the P-4600 replaces the P-4500. Above it in the catalogue sits the larger P-7500, and the US retail price is about USD 13,975.
Key specs that matter
Rated output is 150 W into 8 ohms, 300 W into 4 ohms and 450 W into 2 ohms (20 Hz - 20 kHz, 0.05% THD), against 90, 180 and 360 W for the P-4500. Bridged, it gives 600 W into 8 ohms and 900 W into 4 ohms. THD is 0.03% (4-16 ohms, 20 Hz - 20 kHz). Frequency response is 0.5 Hz - 160 kHz (+0, -3.0 dB, 1 W). Accuphase guarantees a damping factor of 800 or greater and an S/N ratio of 125 dB (A-weighted, gain MAX), with output noise of 19.5 µV. Input impedance is 40 kilohms balanced and 20 kilohms on the line input, and gain is 28 dB. Its chassis measures 465 x 190 x 427 mm and weighs 30.0 kg.
Engineering and use context
Each channel has a 6-parallel push-pull output stage with 150 W, 15 A bipolar transistors, two pairs more than in the P-4500. According to Accuphase, paralleling lowers the output impedance and reduces the load per transistor. A three-stage Darlington configuration drives the output stage. The balanced signal input section uses the instrumentation amplifier principle, with equal impedance on the + and - sides and a gain of 12.6 times. Current feedback amplification and the MCS+ circuit, a two-parallel voltage amplification stage, are used as well. Balanced remote sensing takes feedback from both the signal and GND lines near the speaker terminals and lowers output impedance, THD and IMD.
Instead of a mechanical relay, speaker protection uses a MOS-FET switch with an on-resistance of 1.6 milliohms. Photo-couplers detect a short at the terminals, and temperature sensors sit on the heat sinks. Inside, the P-4600 has a mono-block construction - a custom toroidal transformer and two 50,000 µF filtering capacitors in the centre, with separate left and right amplifier units. The front-panel gain selector has Max, -3, -6 and -12 dB settings and changes the input amplifier gain instead of attenuating the signal. Logarithmic power meters read down to -50 dB.
Pairing
Inputs are balanced XLR and line RCA, with a polarity switch for the XLR. The two pairs of speaker terminals allow bi-wiring or two sets of speakers. A pair of P-4600 units allows bi-amping in dual mono mode or bridged mono operation.
Alternatives
The Accuphase P-7500 is the larger Class AB stereo power amplifier in the same catalogue.