The Accuphase A-48S is a pure Class A stereo power amplifier from the Japanese company founded in Yokohama in 1972. It is the fifth generation of the line that began with the A-45 in 2006, and it replaces the A-48 released in 2019. In the same 465 x 211 x 464 mm (W x H x D) chassis it delivers 50 W instead of 45 W into 8 ohms, and Accuphase quotes a damping factor 25% higher and noise 6% lower than the A-48.
Key specs that matter
Rated output in Class A is 50 W per channel into 8 ohms, 100 W into 4 ohms, 200 W into 2 ohms and 400 W into 1 ohm (music signals), 20 - 20,000 Hz. Bridged, it is rated at 200 W into 8 ohms, 400 W into 4 ohms and 800 W into 2 ohms. THD is 0.03% (4 - 16 ohms) and IMD 0.01%. Frequency response is 0.5 - 160,000 Hz (+0, -3 dB) at 1 W. Damping factor is 1,000. S/N ratio is 118 dB at gain MAX and 123 dB at -12 dB. Gain settings are 28, 25, 22 and 16 dB. Weight is 34.8 kg.
Engineering and use context
Its output stage uses six parallel push-pull pairs of power MOS-FETs per channel, driven in Class A. According to Accuphase, connecting the output devices in parallel lowers the output impedance and the load on each transistor. The signal input section is an instrumentation amplifier with balanced circuits that equalises input impedance on the + and - sides. This section has a gain of 12.6 times (22 dB), and the power amplification section adds 6 dB. The four-step gain selector changes gain in the input amplifier section and does not use an attenuator.
Current feedback amplification and MCS+ circuitry are used in the voltage amplification stage. MCS+ places that stage in a two-parallel layout, and Accuphase states a theoretical noise floor reduction of about 30%. Balanced remote sensing feeds back the ground together with the signal from the speaker terminals and raises the damping factor.
Inside the mono-block construction, separate left and right amplifier engines are powered by a specially made toroidal transformer and two custom 68,000 µF filtering capacitors. Protection uses MOS-FET switches with no mechanical contacts. Power meters read from -50 dB, the top plate has an aluminium hairline finish, and the feet are high-carbon cast iron.
Pairing
Two pairs of speaker terminals are provided. A preamplifier with balanced or line outputs is required, and the polarity of the balanced input is switchable. The operation mode selector allows bi-amping or bridged mono use with a second A-48S.
Alternatives
The Accuphase A-80 is a higher-ranked Class A stereo power amplifier in the same range.