The A-80 is a Class A stereo power amplifier from Accuphase of Japan, developed as a stereo version of the A-300 monaural model built for the company's 50th anniversary. It succeeds the A-75 of 2018. Its unit dimensions are almost the same as those of the A-75, the mass is slightly higher, and rated output into 8 ohms is up by 8%.
Key specs that matter
Rated output (20 Hz - 20 kHz) is 65 W into 8 ohms, 130 W into 4 ohms, 260 W into 2 ohms and 520 W into 1 ohm, the lower impedances limited to music signals. In bridged connection each unit gives 260 W into 8 ohms, 520 W into 4 ohms and 1,040 W into 2 ohms. THD is 0.03% (4 to 16 ohms) and 0.07% (2 ohms), and IMD is 0.01%. Frequency response is 20 Hz - 20 kHz (+0, -0.2 dB) at rated output and 0.5 Hz - 160 kHz (+0, -3.0 dB) at 1 W. Damping factor is 1,000 or greater. S/N is 123 dB with the gain switch at MAX and 129 dB at -12 dB. Input impedance is 40 kohms balanced and 20 kohms line, and input sensitivity for rated output is 0.91 V. Power consumption is 211 W idle and 0.3 W in standby. Maximum dimensions are 465 x 240 x 515 mm (W x H x D), and net mass is 44.6 kg.
Engineering and use context
Each channel has a Class A driven output stage of 10-parallel push-pull power MOS-FETs. Gain is distributed as 22 dB (12.6x) in the signal input section and 6 dB (2x) in the power amplification section. The input section is a fully discrete balanced amplifier taken from the A-300 circuit, built on the instrumentation amplifier principle with equal input impedance on the + and - sides. According to Accuphase, guaranteed output noise is 16.1 µV against 17.4 µV for the A-75, 7% lower. Two MCS+ circuits run in parallel in the voltage amplification stage, and current feedback keeps the frequency response almost unchanged when gain is switched. Balanced remote sensing takes both signal and GND feedback from points close to the speaker terminals.
A large high-efficiency toroidal transformer is followed by two 120,000 µF filtering capacitors, the largest capacity in any Accuphase product. Speaker protection uses MOS-FET switches with 1.6 mOhm on-resistance instead of mechanical relays, with edgewise coils and a gold-plated busbar in the output path. A Hall element detects overcurrent, and temperature sensors monitor the heatsink. Power amplification boards are glass cloth fluorocarbon resin.
Pairing
A preamplifier with balanced XLR or RCA line outputs is required, and the 4-step gain control is set to 28, 25, 22 or 16 dB. Two units allow bi-amping in dual mono mode or bridged connection for 4x output.
Alternatives
The A-48S is the smaller Class A stereo power amplifier in the Accuphase range.