Усилители мощности стерео — AVM Ovation SA 8.3

From the German maker AVM, the Ovation SA 8.3 pairs a tube input stage with a MOSFET output section. It ships in a sturdy AVM flight case and includes a remote control and a dimmable, high-contrast display. Silver and black aluminium cases are offered, plus an optional chrome-plated CELLINI front, and the warranty runs four years after product registration.

Key specs that matter

Rated output exceeds 230 W per channel into 8 ohm, 420 W into 4 ohm and 700 W into 2 ohm. Both XLR and RCA inputs have a sensitivity of 1.25 V, with an input impedance of 40 kOhm balanced and 20 kOhm unbalanced. Gain is 29.5 dB. Frequency response extends from 5 Hz to above 35 kHz at the -3 dB points. Signal-to-noise ratio exceeds 94 dB(A), harmonic distortion stays below 0.02 % and intermodulation below 0.01 %, both at 25 W into 4 ohm. The damping factor is above 400 into 8 ohm, slew rate exceeds 15 V per microsecond. Into 4 ohm the rise time is 10 microseconds, and both figures indicate how quickly the output tracks rapid transients. The chassis measures 420 x 432 x 253 mm and weighs 42 kg.

Engineering and use context

The output section is Class A/B with 24 MOSFETs per channel, capable of up to 60 amperes of current per channel. Signal routing is DC-coupled throughout, without coupling capacitors in the path. Two 1,000 VA toroidal transformers supply the amplifier, and more than 136,000 microfarads of capacitance per channel are integrated on the boards of the output stage to keep the paths between storage and transistors short. Mains supply is 230 V at 50 Hz, maximum draw reaches 3,500 W, idle consumption is 120 W and standby falls below 0.5 W. The idle figure means the unit generates noticeable heat even at low volume, so it needs free space above and around the case.

Pairing

Balanced XLR connection from an Ovation preamplifier keeps the full signal path inside one product family. Because AVM rates output into very low impedances, loudspeakers with impedance dips far under their nominal rating remain within the stated operating range. A preamplifier delivering the rated input sensitivity drives the amplifier to full rated output, which most line-level sources and preamplifiers can supply. Its mass calls for a stable floor spot or a reinforced rack.

Alternatives

The AVM Ovation SA 6.3 belongs to the same series as a lighter two-channel model, rated at 200 W into 8 ohm and 350 W into 4 ohm.