The Reference Phono 3SE is a tube phono preamplifier from Audio Research for moving-magnet and moving-coil cartridges, positioned above the PH9 in the company's phono range. Audio Research says it offers as much performance as the company can pack into a single chassis. Gain, loading and equalisation are selectable for each of its two sets of inputs, and outputs are balanced and single-ended.
Key specs that matter
Tube complement is six 6H30P dual triodes, plus one 6550WE and one 6H30P in the power supply. Gain is selectable at 51 dB (Low) and 73 dB (High) at 1 kHz balanced, or 45 dB (Low) and 67 dB (High) at 1 kHz single-ended. Input impedance is 47 kohms and 100 pF (SE), with selectable loads of 1000, 500, 200, 100 and 50 ohms and Custom. Phono equalisation is selectable between RIAA, Columbia and Decca. Frequency response is ±0.2 dB of RIAA from 10 Hz to 60 kHz, with -3 dB points below 0.3 Hz and above 300 kHz. Distortion is less than 0.002% at 1.0 V RMS, 1 kHz output. Equivalent input noise is 0.28 µV IHF-weighted at low gain and 0.082 µV at high gain. Maximum input is 250 mV RMS at 1 kHz (680 mV RMS at 10 kHz) at low gain. Rated output is 2 V RMS balanced (1 V RMS SE) into a 200 kohm load, and output impedance is 400 ohms balanced and 200 ohms SE. Dimensions are 48 x 19.8 x 41.9 cm (W x H x D), and weight is 16.6 kg.
Engineering and use context
Its gain stage uses high-current 6H30 tubes. Numerous custom parts are used, including proprietary capacitors designed in-house by Audio Research. Low and high voltage supplies are electronically regulated, with line regulation better than 0.01%. An automatic 2-minute warm-up and brown-out mute is built in.
Loading can be changed on the fly. Maximum balanced output capability is 30 V RMS at less than 0.5% THD at 1 kHz, and output polarity is non-inverting. Six push buttons on the front panel cover Power, Menu, Option, Enter, Input and Mute. Power requirements are 100 - 135 V at 60 Hz or 200 - 270 V at 50/60 Hz, with 130 W consumption and 2 W in standby. Handles extend 4 cm forward of the front panel. Audio Research states that every component is hand-crafted and personally auditioned before it leaves the factory.
Pairing
A line input with an impedance of at least 10 kohms is required, and Audio Research recommends 50 - 100 kohms and 100 pF. The balanced output requires a balanced line input.
Alternatives
The Reference Phono 10 is the higher phono stage in the Audio Research range.