The PHO-300 is an MM/MC phono preamplifier in the powerLine range of Vincent, a brand of Sintron Distribution in Iffezheim, Germany. It connects a turntable to an ordinary line input, and Vincent positions it as an affordable model below the PHO-500 and PHO-701. Like those two, it is powered by an external power supply unit, here the PHO-300ps. Both boxes are housed in aluminium cases in black or silver.
Key specs that matter
Frequency response is 10 Hz - 20 kHz (±0.5 dB) and 10 Hz - 50 kHz (±2 dB). THD is below 0.05% (20 Hz - 20 kHz). Gain is 40 dB for MM and 60 dB for MC. Input impedance is 47 kOhm (MM) and 100 ohms (MC), with an input capacitance of 300 pF. Signal-to-noise ratio is above 83 dB (MM) and above 70 dB (MC). Output impedance is 250 ohms. There is one stereo RCA input and one stereo RCA output. Maximum power consumption is 10 W. The phono unit and the power supply each measure 112 x 60 x 126 mm (W x H x D), and they weigh 0.6 kg and 0.9 kg.
Engineering and use context
According to Vincent, the phono unit is built with selected components for low-noise reproduction. An MC/MM switch on the front panel sets the operating mode, and no further adjustment to the cartridge is possible. Vincent specifies the MM setting for MM cartridges and for high-output MC cartridges above 1.5 mV, and the MC setting for low-output MC types.
The PHO-300ps converts the mains AC to a low DC voltage. It keeps the supply to the phono unit constant, so fluctuations in the mains do not reach the circuit. A supplied cable with 5-pin DIN plugs links DC OUT on the power supply to DC IN on the phono stage. Each box has its own power LED, and a GND clamp on the rear is provided for the turntable ground lead. A mains switch sits on the power supply.
Pairing
An amplifier with a free line-level input is required. MC cartridges with an output below 1.5 mV use the MC position with its fixed 100-ohm load.
Alternatives
The PHO-500 is the higher phono preamplifier in Vincent's powerLine, also with an external power supply.