The Evolution Phono Preamplifier is a tube phono stage from Doshi Audio, the American company founded by Nick Doshi, and it is handcrafted in the USA. It is a two-chassis design, with the audio unit and a separate power supply joined by umbilical cords. Cases are anodised aluminium in a natural or black finish.
Key specs that matter
There are three stereo inputs - one differential MC input and two single-ended MM inputs loaded at 10 kohm and 47 kohm, with a 2 MC and 1 MM layout available as an alternative. The MC input can be specified with RCA or XLR connectors. Gain is 20 dB for MC (jumper adjustable to 14 dB) and 50 dB for MM, 72 dB in total. Signal-to-noise ratio is at least 80 dB below 1 V, unweighted, on the MC input. Its two outputs can be specified as RCA, quasi-balanced XLR or transformer-balanced XLR. Doshi quotes 200 ohms output impedance and a 5 kohm minimum load. Tube types are 12AX7, 12AT7 and 12DW7. Power consumption is 29 W, and the preamplifier and power supply together weigh 15.4 kg (34 lbs).
Engineering and use context
Two amplification blocks make up the circuit. With a differential amplifier topology, the MC section has its own power supply and umbilical cord for complete isolation from the MM section. An output transformer couples it to the MM section, steps the voltage down by 6 dB, converts the signal from differential to single-ended and lowers output impedance by a factor of 4. Inside the MM section a 12AX7 is the first stage, a 12AT7 is the EQ driver, RIAA equalisation is passive and is driven by a low output impedance follower, and a 12DW7 hybrid triode is the line driver output stage.
MC loading has 512 settings from 10 ohms to 10 kohm. It is adjusted on the fly from the supplied five-button remote control, which also stores two MC load settings for comparison, mutes the unit and inverts the absolute phase of the MC input. After 30 seconds the display turns off together with the controller microprocessor. A mono switch is optional.
According to Doshi, the power supply is a new design with high stability, a low noise floor and passive power correction. It carries the only power switch and a 12 V DC trigger output. Parts include AudioCapX and ClarityCap CMR capacitors. Isolation grommets decouple the audio circuit board, and the top plate forms a constrained layer. A grounding post takes a separate ground wire from the turntable.
Pairing
The 10 kohm MM input also accepts an external MC step-up transformer. Both outputs are paralleled, so their combined load must stay above the stated minimum. The matching line stage is the Doshi Evolution Line Preamplifier.
Alternatives
The V3.0 Phono Stage is the earlier, now retired Doshi phono stage that preceded the Evolution.