Hifiverse

Cartridges - Vertere Acoustics Ruby One

Description, images, technical data and specifications

Vertere Acoustics Ruby One
Image source - (c) Vertere Acoustics

The Ruby One is the reference moving coil cartridge of Vertere Acoustics, made in England after five years of development. In Japan it went on sale on 20 May 2026 at JPY 2,420,000 including tax, and the US price is USD 12,995.

Key specs that matter

Output is 0.45 mV (5 cm/sec) and coil resistance is 40 ohms. Frequency response is 10 Hz - 50 kHz, with channel separation above 30 dB. The magnet is samarium-cobalt. A nude Micro Ridge diamond (2.4 x 73 µm) sits on a telescopic ruby/aluminium cantilever. Dynamic compliance is 12 x 10-6 cm/dyne (100 Hz), and the recommended tracking weight is 2.05 g (1.90 - 2.10 g). Weight is 11.8 g. Mounting to stylus is approx. 7.8 mm, and headshell to stylus approx. 18.5 mm.

Engineering and use context

Its body is precision-machined from a single piece of solid aluminium alloy. Vertere states that this removes unwanted resonance and gives maximum energy transfer from the groove to the generator. During development the mass and structural balance of the body were tuned to the generator.

Inside is a custom-designed low-mass moving coil generator. Its ruby section is 0.3 mm in diameter, the diamond tip is through-fitted, and the cantilever is mounted to the Cross Coil assembly of the generator. Before this combination was chosen, Vertere tested cantilevers in diamond, ruby and boron and stylus profiles from fine-line to micro-elliptical. A dual-layer suspension of specially selected materials sets compliance and damping.

Vertere holds the generator in its signature Four-Point Generator Floating Support system. Four stainless steel spike screws form this support, each adjusted for alignment, and every generator is individually calibrated and aligned. On the top surface of the body a Special Three-Point Contact design is machined for contact with the headshell and for alignment accuracy. Fixing is through Vertere Tri-point M2.5 threaded holes.

Pairing

A phono stage with an MC input is required. The recommended input load is 1 - 1.5 kohm, with a maximum capacitance of 0.22 µF. M2.5 screws are required for the threaded fixing holes.

Alternatives

The Vertere XtraX is the moving coil cartridge below the Ruby One in the Vertere range.

Specifications

  • Model name

    Ruby One

  • Type

    MC

  • Stylus

    Nude Micro Range Diamond

  • Body

    N/A

  • Cantilever

    Ruby, Alluminium

  • Coils

    N/A

  • Output voltage (mV@5cm/sec)

    0.45

  • Frequency response low +/- 3dB (Hz)

    10

  • Frequency response high +/- 3dB (Hz)

    50 000

  • Internal impedance (Ohm)

    40

  • Channel separation (dB / 1,000 Hz)

    >30

  • Compliance (×10-6cm/dyne at 100Hz)

    12

  • Recommended load (Ohm)

    850 - 1500

  • Recommended tonearms

    N/A

  • Weight (g)

    11.8

  • Official link

Related content