Hifiverse

Cartridges - Clearaudio Concept V2

Description, images, technical data and specifications

Clearaudio Concept V2
Image source - (c) Clearaudio

The Concept V2 is a moving magnet cartridge from Clearaudio of Erlangen, Germany, and the starting model of the company's MM V2 series. It is the only cartridge in that series with an aluminium body. Every other model in the range uses hand-polished ebony.

Key specs that matter

Output voltage is approximately 3.3 mV (1 kHz, 5 cm/s), with a frequency response of 20 Hz - 20 kHz. Channel separation is 20 dB and channel balance 2 dB, both at 1 kHz. An elliptical diamond sits on an aluminium cantilever. Tracking ability is 80 µm, stylus compliance 15 µ/mN, and the recommended tracking force is 2.2 g ±0.3 g. Coil impedance is 0.66 kOhm (1 kHz) and coil inductance is 400 mH. Load resistance is 47 kOhm with a capacitive load of 100 pF. Mass of the complete system is 8.6 g (±0.2 g). Clearaudio gives a two-year warranty if the completed warranty card is returned within 14 days of purchase.

Engineering and use context

Clearaudio's MM V2 technology rests on four points - a low-resonance body, the lowest practical moving mass, optimised HD grinding of the stylus and effective damping of the cartridge. In the ebony models the low-resonance body is wood. Here it is a resonance-optimised aluminium body.

Each moving magnet cartridge of the series is measured and analysed several times and hand-selected in four levels. According to Clearaudio, this selection gives uniform stereo channels and keeps phase and transient distortions low. The company states that the MM V2 models work on all common tonearms.

Pairing

A phono stage with an MM input is required. A standard MM input matches the recommended load resistance and capacitance. The tonearm must reach the recommended tracking force with this cartridge mass.

Alternatives

The Clearaudio Performer V2 is another MM V2 model, with the same output, aluminium cantilever and elliptical diamond in a hand-polished ebony body with 1.5 dB channel balance.

Specifications

  • Model name

    Concept V2

  • Type

    MM

  • Stylus

    Elliptical

  • Body

    Aluminium

  • Cantilever

    Aluminium

  • Coils

    N/A

  • Output voltage (mV@5cm/sec)

    3.3

  • Frequency response low +/- 3dB (Hz)

    20

  • Frequency response high +/- 3dB (Hz)

    20 000

  • Internal impedance (Ohm)

    N/A

  • Channel separation (dB / 1,000 Hz)

    20

  • Compliance (×10-6cm/dyne at 100Hz)

    15 μ/mN

  • Recommended load (Ohm)

    47 000

  • Recommended tonearms

    N/A

  • Weight (g)

    8.6

  • Official link