The DAC140 is a digital-to-analogue converter with tubes from Kora of Toulouse, designed and built in the Occitania region of France. It is the converter of the 140 series, next to the PR140 preamplifier and the CD140 player, and combines a 32-bit, 768 kHz digital section with an analogue output stage based on Kora's Square Tube. It has nine digital inputs. In France it was priced at EUR 8,980.
Key specs that matter
Inputs are four coaxial S/PDIF on RCA, two AES/EBU on XLR, two Toslink optical and one USB B. The USB B input accepts up to 384 kHz, and the other eight take up to 192 kHz at 24 bits. Analogue outputs are on RCA and XLR sockets, with an output impedance below 50 ohms and a bandwidth of 20 Hz - 20 kHz. An AKM chip upsamples to 768 kHz, and a ROHM converter performs the 32-bit conversion. High voltages are +240 V and -240 V stabilised, with 12 V DC tube heating. Chassis size is 100 x 420 x 340 mm (H x W x D), or 118 x 420 x 355 mm overall, and weight is 6 kg.
Engineering and use context
Inside the digital section, a first AKM integrated circuit receives the active input and converts it to I2S. A second AKM circuit oversamples the signal, raising its resolution by a factor of over 64,000 and multiplying the number of converted samples by 16. Kora's own clock circuit keeps all digital signals synchronised before the ROHM DAC.
Four double triodes, four per channel, form the Square Tube operational amplifier, which here also performs pure analogue filtering. According to Kora, the circuit is a differential input stage, symmetrical by nature, followed by an output stage close to an OTL push-pull. It passes DC, and the tube bias is self-stabilising. Each input triode receives a fixed 2 mA from a current source. Two regulated high voltages, positive and negative, supply the circuit with 480 V in total.
Start-up and switch-off are organised by a microcontroller and are silent, and the tube voltages are monitored throughout operation. On a fault the display names it and the converter shuts down. The home screen shows the selected input and the sampling frequency of the incoming signal. Inputs are chosen with the single press-and-turn button or with the DAC INPUT key on the RC5 infrared remote, and a setup menu holds display brightness and encoder click volume.
Pairing
A preamplifier or integrated amplifier with an XLR or RCA line input is required. The matching preamplifier is the Kora PR140, and the USB B input accepts a computer as a source.
Alternatives
The DAC module for the Kora PR140 is a drawer converter with two coaxial and two Toslink inputs and the same 32-bit, 768 kHz conversion.