Hifiverse

Subwoofers - Raidho Acoustics TD10 SUB

Description, images, technical data and specifications

Raidho Acoustics TD10 SUB
Image source - (c) Raidho Acoustics

The TD10 SUB is an active subwoofer from Raidho Acoustics of Denmark, made by Dantax Radio in Pandrup. Raidho presented it with the smaller TD8 SUB at High End Munich 2025, and both models have been available since September 2025. Prices are EUR 23,000 in black and EUR 25,000 in walnut. Raidho describes the two TD subwoofers as the first with diamond-coated drivers.

Key specs that matter

This is an active subwoofer with two 254 mm diamond-coated Ceramix drivers and four 254 mm passive radiators. Bass extension is 20 Hz (±3 dB), and maximum SPL is 122 dB. A 500 W Class-D Hypex Ncore amplifier with 3-4 ms latency is built in, together with PC-based DSP for crossover, EQ and phase. Inputs are analog high-level, RCA and XLR. Dimensions are 480 x 980 x 600 mm (W x H x D) including feet, the enclosure measures 295 x 600 mm (W x D), and weight is 64 kg per unit. Raidho recommends a room size of 30-100 m2.

Engineering and use context

Raidho's Ceramix membranes carry a 10 µm artificial diamond (DLC) layer. According to Raidho, this layer raises stiffness and damps resonances. Each driver has an underhung voice-coil motor. Instead of extreme excursion and heavy DSP, Raidho places the drivers in large enclosures. The passive radiators extend low-frequency output without the turbulence or port noise of a bass-reflex design.

Amplification and DSP come from Hypex and are configured by Raidho for this subwoofer, with driver protection integrated. Settings are made in the Hypex Filter Design software on a Windows PC over a USB Mini-B connection, which is for configuration only and carries no audio. The DSP stores three presets, shipped with low-pass roll-offs at 80, 60 and 40 Hz, and also offers delay, polarity invert, parametric EQ and FIR filters. A gain knob sits on the rear panel. In standby, consumption is under 0.5 W with signal detection on the analog inputs.

An XLR through connector, wired directly to the XLR input, allows a second subwoofer to be daisy-chained. Left and right on the RCA input are mixed internally to mono. Stackable enclosures allow tower configurations.

Finishes are Black Piano and Walnut Burl Piano, with custom colours on request. Walnut burl veneer is matched and joined by hand and bonded to a multi-layer substrate, and each veneer panel carries a serial number for left-right pairing. Every surface gets eight rounds of sanding and sixteen layers of high-gloss lacquer.

Pairing

A preamplifier or processor with an XLR or RCA subwoofer output, or the speaker outputs of an amplifier for the high-level input, is required. Raidho's TD series loudspeakers are the matching main speakers.

Alternatives

The Raidho TD8 SUB has two 203 mm active drivers and two 254 mm passive radiators, with 25 Hz extension.

Specifications

  • Model name

    TD10 SUB

  • Frequency Response low +/- 3dB (Hz)

    20

  • Frequency Response high +/- 3dB (Hz)

    N/A

  • Sensitivity (dB at 1 W/1m)

    N/A

  • Impedance (Ohms)

    N/A

  • Has internal amplification

    Yes

  • Power amplifier (W)

    N/A

  • Size (sm)

    N/A

  • Weight (kg)

    N/A

  • Official link

Related content