The Sub Box 50 E is a compact active subwoofer from Pro-Ject Audio Systems of Austria. It is a sealed cabinet type subwoofer with a single down-firing woofer, and Pro-Ject gives an MSRP of EUR 299 including VAT. High-gloss black and high-gloss white are the two finishes.
Key specs that matter
Woofer diameter is 130 mm. Output power of the built-in amplifier is 50 W RMS, 100 W peak, with a signal-to-noise ratio of 72 dB and THD+N of 0.015% (1 W). Frequency response is 38 Hz - 160 Hz (-3 dB). Crossover frequency is continuously adjustable from 65 Hz to 150 Hz, and a phase inversion switch is provided. Inputs are stereo or mono RCA at low level, with 140 mV input sensitivity, and stereo or mono speaker terminals at high level, with 3.5 V input sensitivity. Power consumption is 0.4 W in standby, 10 W with no signal and 101 W at full power. Dimensions are 205 x 280 x 205 mm (W x H x D), and net weight is 6 kg.
Engineering and use context
Pro-Ject specifies an ultra-stiff, non-resonating MDF cabinet and describes the MDF chassis as rigid. On the rear, a metal back plate carries the inputs and all setup options, including the crossover control and the phase switch.
Two amplifier modes are available, always-on and auto-on. In auto-on mode a signal at any input wakes the amplifier, and the unit returns to standby after 10 minutes without an active signal.
According to Pro-Ject, the high-level input on speaker terminals is intended for power amplifiers. Scope of delivery is the Sub Box 50 E and a manual.
Pairing
A preamplifier, receiver or integrated amplifier with a line-level subwoofer output or pre-out is required for the RCA inputs. A power amplifier or integrated amplifier without such an output connects to the high-level speaker terminals instead.
Alternatives
The Sub Box 50 is the earlier Pro-Ject subwoofer without the E suffix.