The Enigma Veyron Subwoofer, type EV-SB-1.0-A, is the active subwoofer of the Kharma Enigma Veyron collection, which also covers loudspeakers, preamplifiers and amplifiers, an audio rack and cables. It is built from modular levels, and two levels can be stacked. Black brushed and anodised aluminium plates with Macassar wood and gold trim are standard, and the finish can be tailored to order.
Key specs that matter
Its driver is an in-house 381 mm unit with a carbon composite sandwich cone. Kharma lists a frequency range of 17 Hz - 250 Hz, maximum SPL of 117 dB, and amplifier power of 200 W nominal and 400 W peak. The amplifier uses a linear topology with a response of 4 Hz - 180 kHz (+0, -3 dB), THD+N and IMD of -120 dB, a damping factor above 2000, input impedance of 10 kohms, 26 dB of gain and 2.6 V sensitivity. Connections are one balanced XLR stereo input, one balanced XLR direct input, one balanced XLR mono output and an Ethernet port. A single level measures 540 x 780 x 687 mm (H x W x D), and the bottom level is 591 mm high. Net weight is 210 kg.
Engineering and use context
Four-centimetre Bulletwood and aluminium plates form the enclosure. Each level sits on a Diamond stand of tungsten balls on diamond discs, and the bottom level of a stack uses triple-diamond discs so that they do not crack under the total load. Kharma limits a stack to two levels because of the weight limit of the Diamond stand. Under the bottom level an extra felt-lined block is screwed to the stands.
Processing is mixed-mode 64-bit with a latency of 600 microseconds, and control is from an Apple iPad over the Ethernet port. High-pass and low-pass filters offer Butterworth, Bessel and Linkwitz-Riley alignments from 6 to 24 dB/oct. Five PEQ points cover 10 Hz - 20 kHz with Q from 0.2 to 25 and gain from -12 to +12 dB. Five factory presets are stored, and up to 40 custom presets can be saved. With the rear DSP switch off, only the direct input is active and goes straight to the amplifier. A front LED turns red at the current limit, purple when DC is detected and the amplifier shuts down, and white when mains voltage is too low. Mains is set to 115 V or 230 V, and the inlet carries a gold-plated copper isolator.
Pairing
A preamplifier connects to the balanced XLR stereo input. In a master and slave set-up the mono output of the first subwoofer drives the direct input of up to two further units with their DSP switched off. For more than two subwoofers Kharma recommends a separate Enigma Veyron DSP module based on the Enigma Veyron Audio Rack.
Alternatives
The Exquisite Midi Subwoofer is the active Kharma subwoofer of the Exquisite collection, with a 381 mm High Modulus Sandwich Kharma Composite driver.