The BW-3 is a high bandwidth subwoofer from Lyngdorf Audio. Its upper limit in bypass mode extends well beyond the 120 Hz that Lyngdorf gives as typical for traditional subwoofers. The compact cabinet can stand upright or on its side, and the BW-3 is delivered without feet mounted. It is intended as a subwoofer for other loudspeakers in a stereo or home cinema system.
Key specs that matter
The driver is an 8 inch long-throw unit with an aluminium cone and a 38 mm (1.5 in) voice coil. Amplification is 400 W RMS, class D type. The enclosure is a closed cabinet of full MDF construction with an internal volume of 7.25 litres. Frequency response is 27 to 200 Hz using the line input and 27 to 800 Hz using the bypass input. Controls are a bypass switch, phase control (0 to -180°), level control and crossover frequency (60 to 200 Hz). The single connection is an RCA analogue mono input. Cabinet dimensions are 31.5 x 23 x 17.2 cm (W x H x D), and weight is 8.9 kg. Finishes are high-gloss black, matte black and matte white.
Engineering and use context
For this small closed cabinet Lyngdorf designed a custom driver. This woofer has a massive motor, and its diaphragm is aluminium with an inverted dust cap and a single well-defined breakup point. An open basket design allows ventilation below the spider. Together with the vented pole piece, it prevents over- and under-pressure from causing mechanical losses when the cone moves.
Lyngdorf's own class D design is used for the internal amplifier, based on more than 15 years of experience with class D amplifiers. Its amplifier module holds the traditional signal controls as well as the bypass switch, for direct connection to Lyngdorf Audio amplifier outputs or to other audio products.
Pairing
An amplifier or processor with an RCA subwoofer output is required. Speaker-level inputs are not provided.
Alternatives
The BW-2 is Lyngdorf's larger high bandwidth subwoofer, with a 10 inch long-throw driver in a 14-litre closed MDF cabinet.