The Anthra W10 is the most compact subwoofer in the Monitor Audio Anthra series, below the W12 and W15. Monitor Audio intends it for small to mid-sized spaces, as a single subwoofer or in multiples. The series arrived in 2023, when the W10 was priced at GBP 1,650, EUR 2,150 and USD 2,350, and it is offered in Satin White or High Gloss Black.
Key specs that matter
This is an active sealed-cabinet subwoofer with one 254 mm high linear-excursion triple suspension driver and 50 mm of peak-to-peak excursion. Its high-efficiency Class-D amplifier is rated at 500 W instantaneous and 425 W continuous short-term on 240 V, or 450 W and 390 W on 120 V. Lower frequency limit is 17 Hz (-6 dB), and upper frequency limit with the low-pass filter off is 400 Hz (-6 dB). External dimensions are 321 x 321 x 321 mm (H x W x D, without feet), and weight is 20.06 kg. Power consumption is 120 W from a universal 85-265 V AC mains input, and the warranty is 5 years.
Engineering and use context
Monitor Audio states the instantaneous rating as maximum RMS output for an instantaneous signal and the continuous short-term rating as a sine wave for 10 seconds. Amplifier and power supply were designed in tandem for better efficiency and lower distortion. All Anthra drivers combine Rigid Surface Technology II with a C-CAM cone of ceramic-coated aluminium-magnesium, a material with a higher resistance to bending stress. RST II was applied to a Monitor Audio subwoofer cone for the first time in this range and increases cone rigidity.
Inside, the cabinet is braced 18 mm MDF with a 36 mm front baffle, and a cloth grille attaches magnetically. An autoranging input accepts up to 10 Vrms while keeping noise low on small signals, ahead of a 28-bit, 50 MIPS DSP. Low-pass filtering spans 20-200 Hz with slopes from -3 to -48 dB per octave, and phase is adjustable over 0-360 degrees, measured at the crossover. Owners can choose among three predefined EQ curves or set up three custom curves, each an 8-band equaliser with peaking, high shelf, low shelf and high-pass filters. On the back panel a full-colour LCD and rotary dial cover basic setup and EQ preset selection, while the MaestroUnite app holds the DSP configuration and multi-sub setup.
Pairing
A preamplifier, integrated amplifier with pre-out, AV processor or receiver with a line-level output is required. The stereo RCA inputs take a mono or LFE signal on the connector marked LFE, and the balanced XLR input takes mono or LFE. Unbuffered RCA and XLR outputs allow up to four Anthra subwoofers to be linked, with MaestroUnite sending the same settings to each.
Alternatives
Above it sits the Monitor Audio Anthra W12, a mid-sized sealed subwoofer with a 305 mm driver and 1,700 W of instantaneous Class-D power.