Hifiverse

Floorstanding loudspeakers - Martin Logan Motion Foundation F1

Description, images, technical data and specifications

Martin Logan Motion Foundation F1
Image source - (c) Martin Logan

The Motion Foundation F1 is a passive three-way floorstanding speaker from MartinLogan and the smaller of the two towers in the Motion Foundation series. Its footprint is tighter than that of the Foundation F2. MartinLogan lists the F1 at USD 849.99 each, in Black with Gunmetal trim, Walnut with Bronze trim or Satin White with Silver trim.

Key specs that matter

Frequency response is 41 Hz - 23 kHz (±3 dB). Sensitivity is 92 dB and impedance is 4 ohms, with a recommended amplifier power of 15 - 200 W. The lower crossover point sits at 240 Hz. Drive units are a 2.4 x 2.5 cm Gen2 Folded Motion Tweeter S with a 22.6 cm2 diaphragm, one 14 cm aluminium-cone midrange and three 14 cm aluminium-cone bass drivers. Tweeter dispersion is 90° x 90°. The cabinet is rear ported. Dimensions are 105.2 x 21 x 36.7 cm (H x W x D, with feet, binding posts and grilles), and weight is 21.1 kg.

Engineering and use context

MartinLogan's Folded Motion tweeter uses folded thin-film material to pack a large diaphragm area into a small space. The company cites large surface area, light weight and low excursion for the Gen2 FMT S. It is mounted in a Folded Motion Waveguide, which sets the Controlled Dispersion of the tweeter.

Each 14 cm driver has a unibody aluminium cone and a stamped steel basket. MartinLogan derives the aluminium cone technology from its Motion XT and Motion series. Both the midrange and the bass section sit in non-resonant chambers, and the bass chamber has an asymmetrical format.

According to MartinLogan, the McCracken-Vojtko crossover was refined through anechoic and in-room measurements and multiple blind listening tests. Floor Bounce Compensation sets the woofer positions and the crossover tuning so that the reflection from the floor is part of the design. Secure-Lock grilles are held by stealth mounting tabs and can be left on, removed or rotated to change the grain of the fabric. A single pair of 5-way binding posts is mounted on the rear panel.

Pairing

An amplifier rated for 4 ohm loads is required. Bi-wiring is not possible with these binding posts. The Motion Foundation series has five models for a stereo or surround system in the same three finishes.

Alternatives

The Motion Foundation F2 is the larger tower of the same series.

Specifications

  • Model name

    Motion Foundation F1

  • Frequency Response low +/- 3dB (Hz)

    41

  • Frequency Response high +/- 3dB (Hz)

    23 000

  • Sensitivity (dB at 1 W/1m)

    92

  • Impedance (Ohms)

    4

  • Power amplifier requirements (W)

    15 - 200

  • Has internal amplification

    N/A

  • Internal amplification power (W)

    N/A

  • Size (sm)

    105.2 x 21 x 36.7

  • Weight (kg)

    21.1

  • Official link

More components