Hifiverse

Bookshelf Speakers - McIntosh XR50

Description, images, technical data and specifications

McIntosh XR50
Image source - (c) McIntosh

The XR50 is a three-way bookshelf loudspeaker from McIntosh Laboratory of Binghamton, New York. Its four drivers are a woofer with the patented McIntosh LD/HP magnetic circuit, two titanium inverted dome midranges and a titanium dome super tweeter. McIntosh designed it for both music and home theatre systems, and it is finished in real wood veneer under high-gloss polyester, offered in Gloss Black and Red Walnut.

Key specs that matter

The driver complement is one 152 mm woofer, two 51 mm titanium inverted dome midranges and one 19 mm titanium dome tweeter. Crossover frequencies are 500 Hz and 8 kHz. Frequency response is 40 Hz - 45 kHz, sensitivity is 81 dB (2.83 V/1 m equivalent) and impedance is 8 ohms nominal. Recommended power range is 75 - 300 W, with maximum power handling of 300 W. Each cabinet measures 203 x 430 x 299 mm (W x H x D) and weighs 8.9 kg net, or 11 kg in the shipping carton.

Engineering and use context

Inside the woofer motor, LD/HP uses a pair of aluminium shorting sleeves, a design concept that came from finite element analysis. The sleeves reduce the influence of the fluctuating voice coil field on the permanent magnet field, for more linear magnetic flux in the voice coil gap, less compression through heat transfer and a cooler voice coil. McIntosh states ten times less distortion than its previous designs. A rear vent runs through the magnetic assembly, and the die-cast basket has an open area under the voice coil and spider to prevent displacement noise. Its polypropylene cone has a rubber surround and a four-layer copper voice coil.

Both midranges and the super tweeter use neodymium-iron-boron magnets, for smaller drivers and closer driver-to-driver spacing. Between the two midranges sits the super tweeter, for a symmetrical polar response. The second-order crossover network uses high-current, low-loss (DCR) inductors and low-loss (ESR) capacitors, plus self-resetting high-current PTC fuses for protection.

The enclosure has front-to-back and side-to-side internal bracing, non-parallel internal sides and a vertical port with a rear opening. A black knit cloth grille is held by magnetic fasteners, and LEDs behind light diffusers illuminate the front-panel logo.

Pairing

An amplifier of at least 75 W per channel is required. McIntosh gold-plated binding posts accept spade lugs, banana plugs and large-diameter wire. Power Control IN/OUT jacks take a +5 to +12 V trigger from a McIntosh preamplifier through a 3.5 mm stereo mini plug.

Alternatives

The McIntosh ML1 Loudspeaker Mk II is a four-way loudspeaker with five separate drivers and a 305 mm LD/HP woofer, supplied with a matching speaker stand.

Specifications

  • Model name

    XR50

  • Frequency Response low +/- 3dB (Hz)

    40

  • Frequency Response high +/- 3dB (Hz)

    45 000

  • Sensitivity (dB at 1 W/1m)

    81

  • Impedance (Ohms)

    8

  • Power amplifier requirements (W)

    75 - 300

  • Has internal amplification

    N/A

  • Internal amplification power (W)

    N/A

  • Size (sm)

    20.3 x 43cm x 29.85

  • Weight (kg)

    8.9

  • Official link

More components