Hifiverse

Bookshelf Speakers — Tannoy EATON

Description, images, technical data and specifications

Tannoy EATON
Image source - (c) Tannoy

The EATON is the bookshelf model of the Tannoy Legacy Series, a revival of the HPD Series monitors the company made in the 1970s, with cabinets hand-built at the Tannoy workshop in Coatbridge, Scotland. The range also includes the floorstanding Cheviot and Arden, and the EATON is the smallest of the three, with a 10-inch Dual Concentric driver, while the Cheviot uses a 12-inch unit and the Arden a 15-inch one.

Key specs that matter

A 254 mm paper pulp cone covers the bass, suspended by an impregnated fabric surround of twin roll type, with a 52 mm edge-wound voice coil. Mounted at its centre is a 33 mm aluminium-magnesium alloy dome, also with an edge-wound coil, which Tannoy says reaches 30 kHz. The crossover point is 1.2 kHz. Sensitivity is 89 dB, nominal impedance is 8 ohm, peak power handling is 400 W, and Tannoy recommends amplifiers of 20 to 200 W. The cabinet measures 538 x 376 x 250 mm and weighs 19.5 kg in walnut veneer, with a nylon grille.

Engineering and use context

Within this coaxial Tannoy driver the tweeter fires through a Tulip Waveguide in the throat of the horn formed by the bass cone, which acts as a phase plug and aligns the arrival of both frequency ranges from a single point, with dispersion in a 360 degree pattern. Compared with the original HPD driver, the motor uses ferrite with copper demodulation rings in place of Alnico. The crossover has two separate channels, one for each section of the driver. Two controls on the front baffle adjust the treble. ENERGY has five positions (-3, -1.5, level, +1.5 and +3 dB) and shelves the output from 1 kHz to 30 kHz, while ROLL OFF changes the slope above about 5 kHz from +2 to -6 dB per octave. Two distributed ports face forward. The enclosures follow the original HPD design but use high-density materials, the base has 8 mm coupling spikes and bracing uses Differential Materials Technology. The terminal panel carries 24 carat gold plated WBT posts for bi-wiring plus a fifth ground post intended to reduce RF interference. Bi-wire bridges and Prestige wood wax come in the box.

Pairing

The twin terminal pairs let one amplifier feed the EATON through a single cable run or through two separate runs, one to each channel of the dual crossover network.

Alternatives

The Tannoy Autograph Mini-OW is a much smaller oiled walnut bookshelf speaker from the Autograph range, also using a Dual Concentric driver.

Specifications

  • Model name

    EATON

  • Frequency Response low +/- 3dB (Hz)

    40

  • Frequency Response high +/- 3dB (Hz)

    30 000

  • Sensitivity (dB at 1 W/1m)

    89

  • Impedance (Ohms)

    8

  • Power amplifier requirements (W)

    100 - 400

  • Has internal amplification

    N/A

  • Internal amplification power (W)

    N/A

  • Size (sm)

    54.3 x 37.6 x 27.8

  • Weight (kg)

    19.5

  • Official link

More components