The A900 is a headphone amplifier and preamplifier in the A Series from TOPPING, the Chinese maker of DACs and amplifiers, with the model code TP138. It appeared around 2025 and shares the RC23 remote control with the D900 DAC. The A Series also includes the A90 Discrete headphone amplifier.
Key specs that matter
Output power from the balanced outputs is 22 W x 2 into 16 ohms, 14 W into 32 ohms, 7 W into 64 ohms, 3 W into 150 ohms, 1.5 W into 300 ohms and 750 mW into 600 ohms (THD+N < 0.1%). Single-ended outputs give 6 W x 2 into 16 ohms and 3 W into 32 ohms. THD+N is < 0.00006% (1 kHz, A-wt, 500 mW into 32 ohms) and < 0.000055% at 80 mW into 300 ohms, and THD (20 Hz - 20 kHz) is < 0.00003% balanced at 80 mW into 300 ohms. SNR and dynamic range are 151 dB balanced and 143 dB single-ended. Crosstalk is -153 dB balanced, output impedance is < 0.1 ohm, and frequency response is 20 Hz - 40 kHz (±0.05 dB). Gain is -0.1, +10.3 or +19.8 dB balanced, with input sensitivity of 22.0, 7.0 or 2.1 Vrms. Maximum output level is 60 Vpp balanced and 30 Vpp single-ended.
Engineering and use context
On the rear panel are three balanced stereo inputs on XLR/6.35 mm TRS combo sockets and one balanced XLR pre-out. Headphone outputs are two 6.35 mm jacks, one 3-pin XLR, two 4.4 mm and two 4-pin XLR, and output selection covers each jack, all headphone outputs or the pre-out alone. Its pre-out has a 100 ohm output impedance and the same three gain settings. TOPPING quotes an actual noise level below 0.3 µVrms at low gain, measured with a 40 dB low-noise amplifier ahead of an APx555B.
A 2-inch LCD shows Normal, VU or FFT home pages. Control is by touch buttons, a multifunction knob and the remote. Volume steps are 0.5 or 1 dB, and a safe volume mode, adjustable from -80 dB to 0 dB, lowers the level when inputs or outputs are switched or the unit is powered on. Volume memory can follow each output or each input, and two remote buttons store and recall complete presets. Holding two buttons of the RC23 together switches it between the A900 and the D900.
Two 3.5 mm 12V trigger sockets (in and out) switch the A900 on and to standby with upstream and downstream equipment. Mains input is 100-240 V AC, consumption is < 11 W (< 3 W in standby), and the A900 measures 330 x 57 x 200 mm (W x H x D, including protruding parts) and weighs 2.62 kg.
Pairing
The matching DAC is the TOPPING D900, connected over balanced XLR and controlled by the same remote. Headphones from 8 ohms upwards are supported. The XLR pre-out drives a power amplifier or active speakers.
Alternatives
The TOPPING A90 Discrete is the other headphone amplifier in the A Series.