The Ultimate 300 is a two-chassis tube preamplifier with a built-in phono stage from ThivanLabs of Vietnam. ThivanLabs places it at the top of its tube preamplifier line. Its line stage uses 300B triodes in a single-ended, class A, zero-feedback circuit, and the phono section accepts MM, MC and DS Audio optical cartridges. Silver and Black versions are offered.
Key specs that matter
Inputs are three RCA line, one balanced XLR line, one RCA MM phono, one RCA MC phono and one optical phono input for DS optical cartridges. Outputs are one RCA and one balanced XLR (EIA pin 2 hot). The tube complement is two 300B with output transformers and two 6SN7 in the line stage, plus two 12AX7 and two 12AU7 in the phono section. Line gain is +8 dB or +12 dB (switchable), MM gain is 48 dB and MC gain is 68 dB via a step-up transformer. Input impedance is 100 kohms for line, 47 kohms for MM and 22, 47, 100, 220 or 470 ohms for MC. Frequency response is 6 Hz - 50 kHz (±3 dB), hum noise is below 0.1 mV and maximum output exceeds 18 Vp-p into a recommended load above 50 ohms. The amplification module measures 450 x 400 x 290 mm and weighs 24 kg, and the power supply module is 450 x 400 x 150 mm at 20 kg.
Engineering and use context
ThivanLabs develops and produces the output transformers for the 300B stage in-house, and this transformer output has a very low output impedance. Bias is automatic, so 300B and 6SN7 tubes of different brands can be used, in matched pairs. Each 300B sits in a suspension system against external vibration.
Signal wiring is point-to-point, with the shortest possible signal path. The power supply is a separate module connected by detachable umbilical cables. It uses multiple chokes, designed, built and tested by ThivanLabs for noise filtering, and paper-in-oil capacitors for the amplifier stage. Power consumption is 95 W, and the standard 230 V version can be set for 100, 110, 117 or 240 V at 50 - 60 Hz. A straight cable plug is standard and a curved plug is available at extra charge.
The XLR output is a true balanced design. Phono controls are on the top panel, and a High Dynamic/Standard switch is provided. A remote control in the colour of the unit is included, and knobs come in silver or gold for the silver version and black or gold for the black version.
Pairing
A power amplifier with balanced XLR or RCA inputs is required. A separate phono stage is not required for MM, MC or DS Audio optical cartridges.
Alternatives
The ThivanLabs X10 Preamplifier Mark II is another tube preamplifier in the ThivanLabs range.