The STR Preamplifier is a two-channel preamplifier and DAC from Anthem, made in Canada by the Paradigm Electronics group, which also owns MartinLogan. Anthem describes it as an analogue and digital preamplifier combined with a processor. It is offered in black or silver.
Key specs that matter
Frequency response with analogue inputs is 10 Hz - 80 kHz (+0.00, -0.10 dB) in Analog Direct Mode and 10 Hz - 40 kHz (+0.00, -0.20 dB) in DSP mode. THD+N (20 Hz - 20 kHz, 2 Vrms output) is 0.0016% in Analog Direct Mode. SNR (1 kHz, IEC-A, 2 Vrms) is 120 dB in Analog Direct Mode and 113 dB (digital in) or 108 dB (analogue in) in DSP mode. With a 192 kHz digital input the response is 10 Hz - 50 kHz (+0, -0.5 dB). Maximum output (<0.1% THD) is 3.3 Vrms on RCA and 6.6 Vrms on XLR. The asynchronous USB input accepts PCM up to 32-bit/384 kHz and DSD 2.8/5.6 MHz, and coaxial, optical and AES/EBU inputs run up to 192 kHz. Phono input impedance is 100 ohms (MC) and 47 kohms || 270 pF (MM), with 61 dB and 41 dB of gain. Phono SNR in direct mode is 90 dB (MC) and 110 dB (MM). Dimensions are 43.2 x 9.93 x 37.69 cm (W x H x D), and weight is 7.6 kg.
Engineering and use context
In the digital section every input is converted to 32-bit/192 kHz by a dedicated asynchronous sample rate converter, the DAC filter is optimised for this single rate, and the data is reclocked. Signal processing uses 64-bit accumulation and feedback. Thin film precision resistors and low-noise op-amps are used in the DAC circuitry.
Bass management covers two subwoofers, in mono, stereo or as independent left and right channels. XLR and RCA outputs are provided for all channels, the two subwoofers included, and the circuit is laid out with the shortest possible signal paths and differential circuitry.
MM and MC inputs are separate, and the phono section is fully shielded. Six pre-RIAA curves and continuously adjustable settings cover older records. Home Theater Bypass works with the unit in standby, when relays hard-wire the input jacks to the outputs. Up to 30 virtual inputs can be set up, and Ethernet and RS-232 ports allow control system integration.
Pairing
The matching power amplifier is the STR Power Amplifier. A power amplifier with balanced XLR inputs is required to use the balanced outputs. The Home Theater Bypass input connects to the front-channel outputs of an AV processor.
Alternatives
The AVM 70 8K is Anthem's multichannel preamplifier and processor.