The SLP-98 is a two-chassis tube preamplifier from Cary Audio of North Carolina, hand-built and hand-wired there and developed from predecessors going back more than 20 years. Two versions exist. The SLP-98P has a built-in phono stage for MM cartridges, while the SLP-98L is a line-stage model. Both come with a remote control, and the circuit is a class A triode design with matched tubes and zero feedback.
Key specs that matter
Five inputs are provided. Line stage gain is 20 dB and phono stage gain on the SLP-98P is 43 dB. Rated output is 2 V, with 12 V maximum. Input impedance is 50,000 ohms for line and 47,000 ohms for phono, and output impedance is 440 ohms. Frequency response is 5 Hz - 163 kHz, with noise and hum 88 dB below full output. Power consumption is 44 W in operation, from 117 or 234 VAC at 50/60 Hz. Cary gives the dimensions as 127 x 318 x 305 mm (H x W x D) and the weight as 10 kg.
Engineering and use context
Four 6SN7 double triodes make up the line stage, and Cary's owner's manual lists two of them as buffer cathode followers. In the phono section two 12AX7 tubes provide gain and two 12AU7 tubes form the output buffer. As on the flagship SLP-05, the power supply sits in a separate chassis, which according to Cary minimises high-voltage electrical noise. It uses an EI laminate power transformer rated for a 200% duty cycle, full-wave centre-tapped rectification and a pi-network with a filter choke, with four 560 µF 400 VDC reservoir capacitors.
Resistors are 1% metal film types. Coupling capacitors are polypropylene film with hand-soldered copper terminals. On the front panel are a three-position power switch (off, stand-by, operate), a five-position input selector, a mute, a tape monitor, the master volume and separate left and right input level controls. The rear panel carries a ground lug for the turntable, a tape output and dual main outputs. Cary specifies 3 minutes from switch-on to operation and a break-in time of 100 hours. Factory options include Mundorf SilverGold or Jensen capacitors, Hexfreds, Kimber Kable wiring, a home theater bypass and Lundahl MC transformers. The chassis is anthracite black with a silver or black aluminium faceplate.
Pairing
The phono input accepts MM or high-output MC cartridges of at least 1.4 mV. A low-output MC cartridge requires the Lundahl transformer option. Line and phono paths are phase inverting, so the speaker leads are connected in reverse polarity on both channels.
Alternatives
The SLP-05 is Cary Audio's flagship tube preamplifier with an external power supply.