The Allnic Audio L-10000 OTL/OCL Signature heads the line preamplifier range of Kang Su Park's company in South Korea, and the Signature is a revised edition of the earlier L-10000 OTL/OCL. Allnic says it redesigned the entire circuit for this version, including the power transformer, and states that the noise floor fell by more than 50%. The price stayed the same as for the previous edition, USD 30,000. Fascias are made in black and in silver, both with side handles.
Key specs that matter
Five sources fit, three on XLR sockets and two on RCA, and the preamp feeds amplifiers from one XLR and two RCA outputs. Gain is 18 dB. Input impedance is 10 kOhm and output impedance is 200 Ohm on both connector types. Bandwidth runs from 5 Hz to 100 kHz at -3 dB, S/N reaches 100 dB and THD+N stays below 0.03%. The case is 430 mm wide, 450 mm deep and 280 mm high, and the unit weighs 23 kg.
Engineering and use context
OTL/OCL stands for output transformer less and output capacitor less. Three gain stages are direct-coupled, so the single-ended signal path contains neither transformers nor capacitors, and the output tubes connect straight to the power amplifier. Each channel ends in a single-ended push-pull pair of 300B triodes. Drive to the upper and lower 300B grids is kept equal by what Allnic calls an Active Balanced Positive and Negative Feedback Circuit. A floating power supply keeps DC potential away from the output terminals. The layout is true dual mono. The Signature ships with four 300B, two 5814A and two 12AU7 tubes. Volume is set by a 61-step attenuator with silver contacts, which Allnic calls the first bridged constant impedance design of this step count, and the Signature brought a refined version of it. Tube condition is shown by glowing meters, a soft start delays switch-on, and the 300B tubes stand under removable chimneys. A solid metal remote is supplied, and the mains cable enters from the side.
Pairing
Because the 300B output stage drives the power amplifier directly, the L-10000 handles long cable runs and solid-state power amps with ordinary input impedance as readily as tube designs. Both outputs can be used together, for example to feed a stereo amplifier and a pair of subwoofers. The size of the chassis and the tube chimneys need a strong rack shelf with free air above it.
Alternatives
The Allnic Audio L-8000 DHT is a smaller Allnic line stage with directly heated triodes.