The Stereo X is a two-channel class D power amplifier from Peachtree Audio, built on the Hypex NCore X 500 module and housed in a machined aluminium chassis. Its power section is the same one Peachtree designed into the Carina X integrated amplifier, with two modules and one power supply. In the X range it sits between the Stereo 150X and the Mono X, and the regular price is USD 1,799.
Key specs that matter
Rated output is 300 W per channel into 8 ohms and 600 W into 4 ohms (1% THD+N, AES17), with compatible speakers from 2 to 16 ohms nominal. Frequency response is +0.00/-0.03 dB from 20 Hz to 20 kHz into all loads, with the -3 dB point at 70 kHz. THD at 1 kHz and 5 W is below 0.0010% via RCA and 0.0006% via XLR. Signal-to-noise ratio exceeds 100 dB (RCA) and 105 dB (XLR), IMD is -80 dB and -85 dB (SMPTE), and channel separation is above 90 dB. Input impedance is 100 kohms RCA and 47 kohms XLR, sensitivity is 1 V and 2 V, and gain is 33 dB and 27 dB. It measures 300 x 84 x 352 mm (W x H x D) and weighs 5.4 kg.
Engineering and use context
NCore X takes elements of the Hypex Nilai loop filter. Loop gain rises by 6 dB in the top two octaves, error correction exceeds 60 dB across the audio band, and total loop gain above 75 dB gives very low harmonic and intermodulation distortion with negligible output impedance. Hypex quotes half the noise and THD of the earlier NC500. Both channels draw on a single 1,200 W Hypex power supply. The aluminium chassis, shared with the GaN-1, provides the cooling without fans.
Each of the XLR and RCA inputs has its own 12 V DC optically isolated trigger input. When a trigger is sensed, the amplifier powers on and selects the corresponding input, and the front ON/Standby button overrides the choice manually. A rear bi-amp button sends one input to both outputs for vertical bi-amping without Y connectors. On the back panel there is also a ground terminal for REL subwoofers or a Bluesound NODE Icon. Idle consumption is 26 W, and the unit carries CE and FCC approval.
Pairing
A preamplifier or source with its own volume control is required. Inputs accept balanced XLR or single-ended RCA. Two units with the bi-amp button engaged allow vertical bi-amping of a speaker pair.
Alternatives
The Peachtree Stereo 150X is the smaller stereo power amplifier in the X range, with outputs of 150 W per channel at 8 ohms and 250 W at 4 ohms.