The SP-332 is a stereo hybrid power amplifier in Vincent's powerLine. Vincent revised the SP-331 to create it, in line with the SA-32 hybrid preamplifier, and the new VU meters on the front panel are the most visible change from the earlier model. Black and silver versions are available.
Key specs that matter
Nominal output power is 2 x 150 W RMS into 8 ohms and 2 x 250 W RMS into 4 ohms. Frequency response is 20 Hz - 20 kHz (±0.5 dB) and 20 Hz - 50 kHz (±2 dB). THD is below 0.1% (1 kHz, 1 W), and signal-to-noise ratio is above 91 dB. Input sensitivity is 1.35 V, with an input impedance of 47 kohms. Inputs are one stereo XLR and one stereo RCA plus a 3.5 mm Power Control jack, and outputs are 2 x 4 speaker terminals with a second Power Control jack. Tube complement is two 6N16 and one 6N15. Maximum power consumption is 531 W, and consumption in off and auto standby mode is below 0.4 W. Dimensions are 430 x 165 x 430 mm (W x H x D), and weight is 21 kg.
Engineering and use context
Inside, two 6N16 tubes working in differential push-pull form the input stage. A transistor output stage with eight large transistors follows for the final amplification. Its power supply is based on a 500 W toroidal transformer, buffered by electrolytic capacitors with a total capacity of 80,000 µF, and a 6N15 tube stabilises the voltage.
Both the VU meter backlight and the status LEDs switch between red, blue, green and white with a sliding switch on the rear panel. SPEAKER A and SPEAKER B buttons on the front turn the two loudspeaker outputs on and off separately, and an LED next to each button shows the active pair. For bi-wiring, both pairs of terminals are used with A and B switched on. Vincent allows a second pair of loudspeakers only when both pairs have a nominal impedance of at least 8 ohms. Auto standby switches the amplifier off after 15 minutes without an input signal and can be disabled. Each 3.5 mm Power Control jack carries a 12 V trigger for remote standby switching.
Pairing
The matching preamplifier is the SA-32, now offered as the SA-32MK and SA-32AE. Loudspeakers with a nominal impedance of at least 4 ohms are required. A preamplifier with balanced XLR or single-ended RCA outputs connects directly. The terminals allow bi-wiring or two pairs of 8 ohm loudspeakers.
Alternatives
The SP-T700 is a tube power amplifier in Vincent's tubeLine.