The Statement P2 is a 2-channel multi-mono power amplifier from Anthem, made in Canada, and the stereo model of the Statement P Series. It has a Class AB output stage and is rated at 325 W per channel. Anthem launched it in 2005, and list prices were USD 4,999.99 and CAD 5,999.99.
Key specs that matter
RMS output per channel is 325 W into 8 ohms, 500 W into 4 ohms and 675 W into 2 ohms. Input sensitivity is 1.0 Vrms for 100 W into 8 ohms, and voltage gain is 29 dB. Input impedance is 18 kohms (RCA) and 22 kohms (XLR). Frequency response is 20 Hz - 20 kHz (±0.15 dB) and 5 Hz - 100 kHz (±2 dB), with a slew rate of 40 V/µs. THD+N is 0.0007% at 1 kHz and 0.008% at 20 kHz, both at 225 W, and CCIF intermodulation (19 kHz + 20 kHz) is 0.00019% at 325 W. Signal-to-noise ratio is 125 dB (IEC-A, ref. 325 W). Crosstalk is -140 dB at 20 Hz and -80 dB at 20 kHz. Damping factor is above 600 at 20 Hz and 400 at 1 kHz. Dimensions are 238 x 490 x 572 mm (H x W x D, with feet, excluding power cord), and weight is 34 kg.
Engineering and use context
Each channel is self-contained, with its own glass-epoxy circuit board, heatsink and power supply, and there is no common audio path between channels. Inside, toroidal power transformers are dedicated to each channel, and every channel has two separate power supplies fed from distinct transformer windings. The driver stage uses a regulated power supply. Fourteen bipolar output devices per channel make up the output stage.
Anthem uses a Direct-Connected design to the power supply capacitor bank and says it keeps output impedance low. On clipping, an Anti-Saturation Tracking Power Supply circuit takes over for recovery. An output short circuit trips only the AC line breaker, as there are no fuses in the signal path, and self-resetting PTC thermistors protect the standby low-power supply. Each channel has more than 7,258 cm2 of computer-modelled heatsink with serrated fins, no cooling fans are used, and a thermal sensor sits on each heatsink. Its military-spec FR-4 boards have plated through-holes, 2-ounce copper traces and extensive power and ground planes.
A rear three-way switch selects RCA, XLR or attenuated XLR input. Relay trigger input and output use 3.5 mm mono jacks, with Trigger, Manual and Auto on/off modes. The 12-AWG steel chassis carries a brushed aluminium cover and extruded aluminium handles, and an IEC inlet takes a detachable 14-AWG power cord.
Pairing
A preamplifier or AV processor with RCA or balanced XLR outputs is required. Oversize gold-plated binding posts take large speaker cable connectors.
Alternatives
The STR Power Amplifier is the other 2-channel power amplifier in the Anthem range.