Hifiverse

Power amplifiers stereo — Doshi Audio Evolution Stereo Amplifier

Description, images, technical data and specifications

Doshi Audio Evolution Stereo Amplifier
Image source - (c) Doshi Audio

The Evolution Stereo Amplifier is a hybrid stereo power amplifier from Doshi Audio of Charlottesville, Virginia, and it is made in the USA. It belongs to the Evolution series, which also includes the Evolution Line Preamplifier, and Doshi states that it builds on the earlier V3 design. A solid-state input section drives a tube output section, and the price is about USD 24,995.

Key specs that matter

Output power is a minimum of 65 W per channel into 5 ohms. Output tubes are EL34/6CA7. The output transformer is supplied as standard for 5 ohms, and other output impedances are available on special order. Input impedance is 47 kohms (RCA) and 20 kohms (XLR). Noise is 80 dB below 1 W.

Engineering and use context

Its solid-state section is based on a J-FET differential amplifier. Only two gain stages are used, with approximately 7 dB of feedback. Single-ended inputs are direct, while the XLR balanced input passes through a differential to single-ended converter. Doshi specifies an output transformer with separate screen windings.

A custom designed power transformer supplies regulated power supplies, and all Evolution series amplifiers have re-designed supplies compared with the V3 series. Passive components are rated for many times their actual dissipation, and Doshi states that this results in low thermal stress and heat modulation. Coupling capacitors are ClarityCap Purity Series types, mounted on re-designed audio circuit boards.

Mechanical isolation is applied at three levels. Isolation grommets carry the audio circuit board, mass damping of the chassis comes from the top plate, and outrigger legs add another layer of isolation. Its stainless-steel chassis is carried over from the V3 series. There are no user-serviceable parts inside.

Pairing

Speakers with a nominal impedance close to 5 ohms match the standard output transformer, and other loads require a special-order transformer. A preamplifier with RCA or XLR outputs is required, and the matching model is the Evolution Line Preamplifier.

Alternatives

Doshi Audio has no other stereo power amplifier, as its Evolution Monoblock is a mono design.

Specifications

  • Model name

    Evolution Stereo Amplifier

  • Input sensitivity (mV)

    N/A

  • Input impedance (balanced) (Ω)

    20 000

  • Input impedance (single-ended) (Ω)

    47 000

  • Output impedance (balanced) (Ω)

    N/A

  • Output impedance (single-ended) (Ω)

    N/A

  • Max current (A)

    N/A

  • Output power (8Ω) (W)

    N/A

  • Output power (4Ω) (W)

    65 (5Ω)

  • Gain (dBu)

    N/A

  • Frequency response low +/- 3dB (Hz)

    N/A

  • Frequency response high +/- 3dB (Hz)

    N/A

  • Signal to Noise Ratio (dB)

    80

  • Total Harmonic Distortion + Noise (0% global feedback) (%)

    N/A

  • Total Harmonic Distortion + Noise (100% global feedback) (%)

    N/A

  • Max power consumption (W)

    N/A

  • Damping factor

    N/A

  • Dimensions (mm)

    N/A

  • Weight (kg)

    N/A

  • Official link