The Rotel C8 is a Class AB custom installation amplifier with eight channels arranged as four stereo zones. It is listed among Rotel's multi-room hi-fi amplifiers and is intended for rack mounting in multi-room and whole-house systems, with its own source matrix and per-zone controls.
Key specs that matter
Rated output is 50 W per channel continuous into 8 ohms and 70 W per channel maximum into 4 ohms, both with all eight channels driven. Bridged, a pair of channels gives 140 W into 4 ohms. THD and intermodulation distortion are each below 0.1%. Frequency response is 10 Hz - 100 kHz (0 ±0.5 dB) and the damping factor 80 (20 Hz - 20 kHz, 8 ohms). Input sensitivity is 0.3 V at 31 kohms, with input overload at 2.8 V. Signal-to-noise ratio is 100 dB (IHF A) and crosstalk is better than 50 dB. Power consumption is 570 W, below 0.5 W in standby and below 2 W in network standby. The chassis is 2U high (88.1 mm front panel), measures 430 x 97 x 414 mm and weighs 16.7 kg. It comes in black only.
Engineering and use context
An oversized toroidal transformer manufactured in Rotel's own factory supplies sixteen high-current output devices through an array of bulk storage smoothing capacitors. Two thermostat-controlled cooling fans raise their speed with the internal temperature. Each zone is monitored for temperature and muted if it exceeds the limit, and thermal sensors embedded in the transformer shut the unit down in case of overheating.
Four analogue inputs, A to D, are available to every zone through internal matrix switching. A Priority Zone PA Override routes announcements to all zones. From the front panel display and controls each zone gets its own source, volume, bass and treble, with ±10 dB at 100 Hz and 10 kHz. Slide switches bridge zones 1 and 2 or zones 3 and 4. A line output passes input A on to further amplifiers, up to eight units in a daisy chain, and a mono switch combines the left and right signals of input A.
Speaker wires connect through detachable Phoenix terminals with secure-locking screws. For integration there are IP control over Ethernet, RS232 and a 12 V trigger input and output accepting 3 - 30 V AC or DC. No top or bottom clearance is needed in a rack, and the rack ears are included.
Pairing
Loudspeakers of 4 ohms nominal or higher are required. Line-level sources or zone outputs of a control system connect to the RCA inputs A to D.
Alternatives
The Rotel C8+ is the higher-powered eight-channel version, with 150 W per channel into 4 ohms and four additional digital inputs.