The AMG STA-SE is the Special Edition of NuPrime's AMG STA stereo power amplifier in the AMG series. It combines a Single-Ended Non-Negative Feedback class A module with a Double Feedback class D module and can be bridged into a 300 W mono amplifier. Existing AMG STA units can be upgraded to SE status through the country distributor or service center. Its finish is grey, the US price is USD 1,999 and the warranty is two years.
Key specs that matter
Stereo power is 2 x 130 W into 8 ohms and 2 x 200 W into 4 ohms. In mono mode the output is 300 W into 8 ohms and 320 W into 4 ohms. Rated current is 10 A, with 15 A peak. Gain is 28.3 dB in stereo and 34.3 dB in mono (voltage gain 26 and 52), and sensitivity is 1.2 Vrms in stereo and 0.95 Vrms in mono. Input impedance is 1 Mohm, and output impedance is 20 mohm. Frequency response is 10 Hz - 50 kHz (±0.2 dB, 8 ohms), with the -3 dB point at 58 kHz. S/N is 100 dB (10 W), and THD+N is 0.006%. Dimensions are 55 x 235 x 300 mm (H x W x D), and weight is 4.5 kg.
Engineering and use context
A 300 MHz bandwidth JFET is used at the input. Its class D oscillation fundamental frequency is 700 - 750 kHz, and in the SE circuit MOSFET temperature is 30% lower during high-speed operation. Negative feedback sampling uses aerospace-grade precision resistors with a 1/1000 error margin and a temperature drift coefficient of 15 ppm. NuPrime also added a newly devised secondary negative feedback circuit. Large-capacity supply capacitors and low-impedance routing of the main current path raise instantaneous supply current to 1.5 times that of the original AMG STA.
Inside, a 380 W special winding power transformer is used, and NuPrime quotes 30% more peak power than a transformer of similar volume. A 20 A locking terminal block connects the transformer to the motherboard, and two 10 A peak current rectifiers are connected in parallel. A redesigned SMPS module supplies the low-voltage circuits, a new AC power supply reduces radiated noise, and ground wire shielding is integrated into the PCB.
In mono mode the amplifier uses Single-Ended Direct-Inject Bridge Technology rather than the usual op-amp inversion of one channel's input. A toggle switch configures the RCA or XLR input, and only one of the two may be connected. Its front panel is milled from 15 mm hardened aerospace aluminium alloy on a four-axis CNC machine with a diamond cutter in a 48-step process.
Pairing
A preamplifier with an RCA or XLR output is required. The matching preamplifier is the AMG PRA. Two units in mono mode form a pair of monoblocks. The AMG DAC remote control can switch the amplifier on and off.
Alternatives
The STA-9X is NuPrime's 2 x 130 W class A+D stereo power amplifier, bridgeable into a 330 W mono amplifier.