Aegir 2F is a stereo power amplifier from Schiit Audio that combines Halo mixed-mode motion feedback with the Continuity output stage, and Schiit calls it a compact, Class-A-ish amplifier. The F version carries Forkbeard, and the Aegir 2 is otherwise identical. Chassis, transformers and PCBs are made in California, and final assembly takes place in San Antonio, Texas. Price is USD 949 to 999, as ordering without the Forkbeard module saves USD 50, and the limited warranty covers parts and labour for 5 years.
Key specs that matter
Power output is 30 W RMS per channel into 8 ohms and 50 W RMS per channel into 4 ohms in stereo, or 100 W RMS into 8 ohms in mono. Frequency response is 20 Hz - 20 kHz (-0.1 dB) and 3 Hz - 550 kHz (-3 dB). THD and CCIR IMD are both below 0.005% at 20 W RMS into 8 ohms. SNR exceeds 122 dB (A-weighted, referenced to full output), crosstalk exceeds 95 dB (20 Hz - 20 kHz) and damping factor is above 10 into 8 ohms. Gain is 12 (22 dB). Input impedance is 22 kohms single-ended and 44 kohms balanced, with an L/R pair of RCA jacks for stereo and a single XLR for mono. Power consumption is 250 W maximum and 1-2 W in standby. Size is 9 x 13 x 3.875 in. (229 x 330 x 98 mm), and weight is 9.5 kg.
Engineering and use context
Topology is fully complementary, all-BJT and current feedback, with no coupling capacitors or DC servos. According to Schiit, Halo is a mixed-mode feedback topology that incorporates the loudspeaker into the gain stage. Continuity uses NPN and PNP devices on both rails and turns on additional devices to compensate for transconductance droop outside the Class A bias region and runs less bias than Class A. Against the original Aegir it has twice the number of active output devices and a single optimised corrector, as in the Tyr.
Its linear power supply starts with a 600 VA toroidal transformer, with dual mono main rails, 16 Schottky rectifiers and over 150,000 µF of filter capacitance. Five regulated rails include two discrete regulated rails for the boosted supply to the input, voltage gain and driver stages. A microprocessor on separate isolated rails monitors critical operating points and shuts the amplifier down by relay for overcurrent, thermal, DC and other faults. Forkbeard reports Class A status, power output, temperature and overcurrent, and switches standby remotely.
Pairing
Mono operation requires a preamplifier with true balanced, differential outputs, such as the Schiit Freya or Kara. Two units driven this way form a monoblock pair.
Alternatives
The Vidar 2F is the higher-power stereo power amplifier from Schiit.