The A35.8 is an eight-channel power amplifier from Primare of Sweden, for multichannel home cinema and for two-channel systems with bi-amplification. Each pair of its channels can be bridged to mono, and maximum total output is 1,500 W with all channels driven. Its output stage uses eight Hypex NCore500 class D modules, one per channel. MSRP is EUR 5,000.
Key specs that matter
Output power per channel is 150 W into 8 ohms, 300 W into 4 ohms and 400 W into 2 ohms (1 kHz). A bridged pair gives 740 W into 8 ohms (clipping protection limited), 750 W into 4 ohms and 450 W into 2 ohms. Frequency response is 20 Hz - 20 kHz (+0.2/-0.5 dB), THD+N is below 0.005% (20 Hz - 20 kHz, 10 W into 8 ohms, AES17) and signal-to-noise ratio is above 115 dB. Each channel has an RCA and an XLR input, with input impedance of 15 kohms (RCA) and 36 kohms (XLR). Gain is 26 dB via RCA and 20 dB via XLR, and output impedance is below 0.02 ohms. Dimensions are 430 x 400 x 145 mm (W x D x H) and weight is 15 kg.
Engineering and use context
Primare designed a new switch mode power supply for the A35.8, rated at 1,500 W against 900 W in the A35.2. It is an Active Power-Factor Correction (APFC) supply with dual PFC converters operating 180 degrees out of phase, and it runs in transition mode. Dual outputs of the supply serve each group of four amplifier modules. Soft clipping circuitry is included.
Each NCore500 module uses a non-hysteresis 5th order self-oscillating control loop with feedback taken only at the speaker output. Its standard aluminium heat sink plate is removed, and the module is mounted directly to the heatsinks, which also shield the amplifier sections. The module outputs are connected directly to five-way binding posts without solder. Circuit boards are four-layer, with SMD devices wherever possible.
Auto-sense turns the amplifier on from standby, and auto-standby follows after twenty minutes without an input signal, a function that can be turned off. Eight internal red LEDs, one per module, flash on clipping, and a second set of eight warning LEDs indicates DC or overheating. Control connections are two 12 V triggers (in/out) on 3.5 mm jacks and RS232. Finishes are black or titanium.
Pairing
A surround processor or preamplifier with RCA or XLR outputs is required. For 5.1.4 and 7.1.2 layouts, Primare adds an A35.2 stereo amplifier for the front left and right speakers. In a stereo system, all four bridged pairs allow bi-amplification of two loudspeakers.
Alternatives
The A30.7 is an earlier seven-channel Primare power amplifier for multichannel systems.