The A-2000 25th Anniversary is a stereo push-pull valve power amplifier that Allnic Audio released to mark a quarter century of the company. Against the original A-2000 it swaps the KT88 output valves for the larger KT150, gains bigger output transformers and sits in a redesigned chassis with a swept front, finished in black or silver. Its US price was USD 9,900.
Key specs that matter
Rated output into 8 ohm at 1 kHz is 100 W per channel with the KT150 in pentode connection, halving to 50 W per channel in triode. Voltage gain is 26 dB, and full rated output needs an input of 1.3 V through an input impedance of 100 kOhm. Allnic quotes 0.17% distortion at 1 kHz and 10 W, a flat response from 20 Hz to 20 kHz, a CCIR-weighted signal to noise ratio of 80 dB and a damping factor of 8. The case measures 430 x 430 x 240 mm (W x D x H), while the boxed amplifier weighs close to 40 kg.
Engineering and use context
Per amplifier, Allnic fits two 5654 pentodes in the first gain stage, four E282F valves as second-stage drivers and four KT150 in the output stage. The E282F drivers work in triode connection with a load of around 5 kOhm and a current of about 20 mA. Each channel feeds its loudspeaker through a 114 mm output transformer with a nickel-alloy core. Beside the main power switch on the fascia, a button changes the output stage between pentode and triode operation with the amplifier running. Every KT150 is protected by its own fuse, and plate voltage is delayed by a soft-start stage until the heaters are up to temperature. Bias is checked on panel meters, with small screws beside each meter for adjustment as described in the manual. The rear carries one set of loudspeaker terminals per channel, plus balanced and unbalanced line connections, and each channel has its own switch to pick between the two. Handles on the back and the rear of the top panel help when the amplifier has to be moved.
Pairing
The standard outputs serve 8 ohm and 4 ohm loudspeakers, and a 16 ohm version can be ordered from the factory for older or high-impedance designs. Pentode mode gives the reserve needed for floorstanding speakers of average efficiency, while triode mode is the setting for sensitive horns or compact monitors in a smaller room. Both a balanced valve preamplifier and a source with fixed RCA output can feed it directly, since each channel picks its own input.
Alternatives
The Allnic A-2000 mk3 is the later revision of this stereo amplifier, moving to KT170 output valves in a vibration-resistant chassis.