The FM 1811-MKII is a stereo power amplifier in the Resolution Series of FM Acoustics, the Swiss company based in Egg near Zurich. Every unit is built by hand to special order at the FM Acoustics facilities in Switzerland. Pre-assemblies are tested and calibrated, and each finished amplifier goes through multiple pre- and final tests by three different engineers.
Key specs that matter
Guaranteed minimum output per channel, both channels operating, is 500 W RMS into 8 ohms, 1000 W RMS into 4 ohms and 1700 W RMS into 2 ohms, or 1000, 2000 and 3400 W peak. FM Acoustics quotes a repetitive impulse power of 4600 W per channel for comparison with other makers. Maximum output voltage is 184 Vpp, and continuous output current is more than 80 A per channel. Gain is 30.1 dB, rise time at full power (-3 dB) is 3 µs and maximum input level is +20 dBm. Interference rejection is better than 95 dB. Hum and noise are typically -115 dB below full power and better than -100 dB unweighted. Dimensions are 445 x 275 x 530 mm (W x H x D), and weight is 47 kg net.
Engineering and use context
Its input is proprietary, electronically balanced, discrete class A circuitry that works in non-inverting or inverting mode. Single-ended sources are balanced automatically right at the inputs. New symmetrical input stage modules are followed by high-linearity driver stages. No fuses and no current or voltage limiting are used, and FM Acoustics specifies no minimum load impedance, with a design range from below 1 ohm to above 10,000 ohms for dynamic, electrostatic, ribbon and planar speakers. An on-board system guards against short circuit, open circuit, HF oscillation, RF interference, positive and negative DC offset, parasitic frequencies and over-temperature.
A dual chassis isolates the electronic and mechanical components from induced resonances, and tuned anti-resonance isolators are included. Inside, a hand-assembled, layered and frozen transformer of specially treated steel weighs 21 kg. Capacitors are custom-made to proprietary specifications. Consumption is 200 W at idle, 1400 W at 30% power and 3600 W at full power. Factory burn-in lasts at least 100 hours (500 thermal cycles), and the vibration test at least 60 minutes. Spare parts are guaranteed for a minimum of 10 years.
Pairing
A dedicated low-impedance mains line rated at 16 A continuous and 65 A peak at 220-240 V, or 32 A continuous and 130 A peak at 110-120 V, is required. The outputs are FORCEPLUG 200 connectors rated at 1200 A peak, and FORCELINES 3 speaker cables are required.
Alternatives
The FM 711-MKIII is another FM Acoustics high power amplifier in the Resolution Series, originally introduced in 1996.