XP-A2000 is a monoblock power amplifier from Extraudio, a high-end audio company that has designed its products in the Netherlands since 2008. It belongs to the Origin line. Its electronic design is based on one fully separate monophonic power amplifier module with balanced inputs. The front panel carries a single power button, and everything else is controlled by software inside the amplifier. Finishes are black, white and grey.
Key specs that matter
Ultra output power is 1500 W into 8 ohms and 2400 W into 4 ohms. Voltage gain is 28 dB, and frequency response is 2 Hz - 110 kHz (+0 dB). Noise floor is -160 dB at 4 ohms, dynamic range is greater than 120 dB and THD+N is 0.003% (1 kHz, 1 W). Damping factor is greater than 1000 (8 ohm load, 1 kHz and below). Input impedance is 7.2 kOhm balanced (XLR) and 3.6 kOhm unbalanced (RCA). Power consumption is 19 W at idle and below 0.5 W in standby. Dimensions are 440 x 120 x 400 mm (W x H x D), and weight is 18 kg.
Engineering and use context
Extraudio describes the XP-A2000 as a dual power supply, fully balanced power amplifier. Both the RCA and XLR inputs go to a pure class A input buffer with polarised BJT transistor stages. Output power comes from Extraudio EPAM amplification modules. One 1500 W peak power supply delivers a total peak output current of 90 A, and its RMS power limit is 1500 W. Three EMI and RF anti-interference AC input filters are installed. Consumption is managed by Extraudio's own energy efficiency control software, and a microcontroller keeps the amplifier at a low operating temperature. Built-in protection covers temperature, electrical overvoltage, DC and HF.
Solid panels of 6000-series aeronautical aluminium form the chassis. Four WBT Classic Signature Platinum binding posts can be configured at the factory for bi-wiring at 1500 W x 1 or bi-amplification at 800 W x 2. A ground binding post for grounding free loudspeakers and trigger input and output connectors are also on the rear panel. The paint has a ceramic finish under a High Gloss varnish mixed with bi-component epoxy.
Pairing
A stereo system requires two units. A preamplifier with a balanced XLR or unbalanced RCA output is required. The trigger connectors allow switch-on from a preamplifier with a trigger output, and the matching preamplifier is the XP5 MKII.
Alternatives
Extraudio makes no other monoblock power amplifier.